My copystar copier displays time for maintance, what should i do?

Setting the Time Zone

1 Access Time Zone.

If you are unsure how to use this route map refer to Accessing Menu Items on

page 3-3.

2 Press arrow keys to select the time zone that you are in.

3 Press Enter. The message display shows Completed and returns to the Date/

Timer Set. screen.
4 Press right Select. The message display returns to the basic screen.

NOTE: Periodically check the time that is shown in the message display and adjust

as necessary to match the current time.

1 Access Year/Time.

If you are unsure how to use this route map refer to Accessing Menu Items on

page 3-3.

2 To set the date, for each field press arrow keys as many times as necessary to

display the correct value then press arrow keys to move to the next field.

3 When the date is correct, press Enter. The time setting screen

(hour:minute:second) is displayed.

4 To set the time, for each field press arrow keys as many times as necessary to

display the correct value then press arrow keys to move to the next field.

5 Press Enter. The message display shows Completed and returns to the Date/

Timer Set. screen.
6 Press right Select. The message display returns to the basic screen.

hold down the STOP key for ten seconds and record the reading appearing on the display

Hello sir; It's a fuser problem, but you need to reset, the procedure as follow; Press and holding down following keys in order, "stop/reset", "start", and "left copy density", then press "stop/reset" key again, then enter U63 press "start", window will display "CLE", press start again to clear.

Depress the [Stop/Clear] key for 3 seconds. The Copy Count will be displayed on the No. of Copies display.

Pressing on the [Start] key while the Copy Count is
displayed will output the Counter Report.

hi if enter simulation 1087 1087 and select 000 inmidiatly appear d-l and press enter
after to out do you enter with arrow up and down the number 1 in the display and press enter

Your copier is adding toner.Since they cant make a "T" with a 7 segment display, they used a "P" for powder.If it does not go away, replace the toner cartridge and wait a few minutes. Good Luck!

Hello, 'OP' means that the front or upper front cover is open --- close the cover securely. If the message is 'OP1" then the left cover of the document processor is open, close that securely.

Your problem is heat related, or the lack of heating at least. one of 2 things went wrong here... either the fuser unit overheated causing the thermal fuse (aka the thermostat) to blow, or the heating lamp in the fuser unit is blown. Basically the 6000 code is displayed when your machine fails to reach the correct temparature at a specific time. Unfortunately you will have to call a service person to check which to of the mentioned components are at fault and to replace that component for you. After replacing, the component the code will still be displayed as a safety measure, so the service representative will need to clear the code via the machine's service mode

You need to run sim U163 to reset fixing heater problems. Press and hold stop, start, and left exposure key in that order. Release and press stop again. Use zoom keys to enter 163, press start. Exit the mode by entering 001 and start, or power off/on.

You have System settings button on the copier control panel,Press it. Navigate through menu and find date and time settings. if password is requested, try code 2000.
Regards.