My movincool 36 won't work - Stuck in HP Fail

Question edited for clarity, spelling, full 'make model (what is is)'.

You need a refrigeration engineer to check the gas level.

https://www.movincool.com/classic-series/classic-10/

https://www.google.com/search?q=Movincool+classic+10

..

Make sure the camera hot shoe is clean and also the spring assisted contacts on the flash as in for order.

https://www.google.com/search?q=Olympus+Fl+36+flash+won%27t+access+TTL

..

The fan surround is often made with a semi rigid card material called 'Fish Paper', and in time it can get distorted. Sometimes you can just bend it, or just trim it away a bit.

https://www.google.com/search?q=movin+cool+office+18+rattling+noise

..

There should be a door-actuated limit switch which detects that the door is closed, which is probably defective. Look for the plunger, listen for the click. It is the most likely component to fail, and is inexpensive to replace if you're handy. Be sure to have your machine unplugged during repairs.

does the unit work at all? mobile a/c units normally shut down if they cant get rid of the condensate. they have a float switch that shuts them down untill you empty the tray, not sure what AS is though

Hi dbarnard2025,Just  a guess here, but have you checked that the filters and coils are clean?regardscol www.digitalcontrols.com.au

pls adjust the thermostat if no change the sensor

There is a switch on the hot shoe to detect the external flash. When you use an external flash, the switch will be pressed down, then the unit will bypass the internal flash and won’t let it fire. If the little switch gets stuck somehow, you won’t get your internal flash on.
Check this switch on the hot shoe (either on the left side or the right side), blow some compressed air then plug/unplug an external flash several times. Hopefully you can get it back

When the temperature indicator flashes indicate then the temperature has ridge a level lower the the set temperature for example if you set you fridge side to 36 degree and and has fail to stop from getting cooler and has ridge 34 degree. some times those friges fail to calibrate them self tray by unplugging you dirge for 30 seconds and replug it then the board will auto calibrate for the next 24 hours If this problem comes back again that meas than your defrost element on the fridge side is bad.

You are trying to draw too much power from the dedicated electrical line, or you may have an outlet that is needing replaced. Try to use another plug, in another room to test