How to replace waste toner bottle on lanier SPC231SF

IF YOU CAN NOT REMOVE IT TO DUMP THE STUFF THAT IS IN IT OUT I WOULD SAY YES GET A NEW ONE

fuser error will need to fix fuser first then reset code

The boys at the office figured out how to get out and empty... Thanks for all your input... I had sent it on to them.

U14 - Toner waste bottle full. Replace the waste bottle (plastic box at the bottom middle) with a new one or try to empty it.

U14 is a user code for waste toner full.
Open front cover and you will see a clear plastic bottle at the bottom of the machine; lift this out and dispose carefully of waste toner (do not reuse). When fitting back into machine, make sure that inside of bottle is clean as the detection sensor looks through the bottle to see if it is empty and if toner is covering inside of bottle, the message will remain.

What kind of copier is it? On many of the Lanier color copiers, the waste toner bottle is located on the lower left side inside the front door.

Turn the copier off first. Pull the big front door open and turn the bottle with the oil to the left -- the waste toner bottle is the plastic gray tank behind that. Slide it out (carefully) and dump it in a plastic trash bag, then reinsert it.

If you have a different kind of copier, please specify the model and I'll tell you how to get to the waste toner bottle.

Open the machine and to the right under the drum you should see the the black powder (toner) going down into container the right lower side  cover must come off. probably a service call will be needed

Hello sir; I believed you talking about LD045, am I right? In this model it doesn't have waste toner bottle, the only place you can clean is imaging transfer unit, after you cleanup the message will be disappear.

good day, it wont print, coz you must pul the waste toner out. and replace a new waste box.

Is this a small table top model? They usually do not have a waste bottle. The waste toner accumulates is the drum housing Where hopefully the change drum warning will come on before the waste toner fills up and causes poor copies. I have taken the drum asm apart and vacuumed the toner out.

I’m happy to help further over the phone at https://www.6ya.com/expert/jayw_0e86fb055a7b73de