How to reset time on coffee maker - Black & Decker Coffee Makers & Espresso Machines

just plug it out from the wall current for about half day so that the coffee maker can reset itself then plug it in back.if that does not work that means the timing transistor is faulty.you will have to have it repaired.good luck.

You didn't say how you cleaned it but changing the filter shouldn't render it inoperative there is a reset button to reset the change filter timer but that shouldn't cause it to fail..Need more info.

Simply hold down the 'H' button until the machine beeps. Then proceed to set the time using hour and minute buttons. Top left button is for auto brew feature only.

spoke w/ Cuisinart. Unplug unit for 1 hr, then plug back in, reset clock & Auto Off setting. This resets the unit back to the factory settings.

Unplug the coffee pot and push in the "1-4" and "TSB" buttons at the same time, hold the buttons in for a few seconds. This will reset the pot and you should be able to brew like normal after that.

I was able to fix my little problem. I unplugged my coffe maker and waited 'bout 10 mins for the whole thing to shut down. Once the clock shut off, I reset the time. Secondly, I pressed the on/off button and held it in for 2 seconds until the red light started flashing. I set H to 1 and M to 59(I have never seen this before). anyhoo, afterthat, I set the timer to the exact time I wanted to smell my freshly brewed coffee. This morning, the red light seemed to stay on and kept my coffee nice and hot.

Here is the basic troubleshooting for the Cuisinart coffee makers:
Make sure all baskets are in proper place – especially if unit is beeping.
Do not use a paper and a gold-tone or other permanent filter at the same time.
Unplug for LONGER THAN 15 full minutes to reset.
Clean by brewing 2 oz of distilled white vinegar/2 oz water.
If these methods fail, the unit probably requires replacement – call Cuisinart as they have a longer-than-standard warranty.
-Tha Mp3 Doctor

Have you unplugged it? Sometimes unplugging and waiting a day or so resets the computer inside the unit.

I have had this happen too. You need to unplug the unit so that it resets itself. After you re-plug it in you need to set the time. If you just reset it without setting the time it will happen again. This has happened to me a few times. Good luck!