I have a Jenn-Aire cook top w/ grill. # JDS 9860 AAP MODULAR W/ DOWNDRAFT Bought about 1 year ago. Just trying to install it.The unit was stored and somehow the instruction were lost. Just need to know what type of duct is needed. Many thanks
Rush Button
Minimal 6" duct no more than 20 feet long and 90's count as 5 feet. 90's must not be closer than 18" this will meet local codes regarding the venting also an approved exhaust hood. (not a dryer vent)
We're buying a JES9900BAF for an island and found ducting instructions in the installation guide. Go to jennair.com and find the page for your range model. Then click on the "Specs/Literature" tab (it's about 2/3 down the page). The installation guide is a PDF document.
11,793 views
Usually answered in minutes!
I'm about to purchase the Jenn Air 9900 and want to know if I can do the downdraft installation myself. Where do I find the instructions for the installation of the downdraft...? George ([email protected])
no duct work instructions on the Jenn Air website. it would be helpful since i plan to put the down draft cook top in an island - so the duct work needs to be done before the ceiling in the basement below goes up.
We have a Jenn-Air oven and want to put in an island with a cook top. We have a house on a slab and it has a second story. The island is about 6 feet from the oven and need to know your opinions on how to draft the island which will sit in the middle of the room.
We have a problem with the vent on our Jenn-Air gas range.
We have a crawl space underneath the house and the vent goes down through the floor and out the side. However, we are getting cold air back up through the vent, causing quite a draft. The flap on the outside vent closes and opens properly. What else could be causing this back air to come up form the outside??
My Jenn Aire is a downdraft through the slab to outside. Problem is this unit ducts off the unit back toward the cabinet wall with not enough space to us a 90 round duct. It must use some sort of flat rectangular duct that transitions to a round duct. Where do I get such a duct? Any ideas?
Thanks,
Randy
×