Getting error message on my unit

Sorry I don't have the error info for the factory installed unit.

The audio unit is bad, aftermarket radios are cheaper than a OEM rebuilt if you don't have extended warranty.

Check the changer and see if cds are inserted correctly or if 2 cds are in one slot.

Unit has bad disk t-table motor

1. FACTORY RESET METHOD (Temporary) 
(This isn't the most effective, but it is the easiest to try, so it's worth a shot since it apparently works on some units.) 
** Go to the Menu 
** Get to the Settings Menu 
** Select <yes> to Reset to Factory Settings. 
Credit: DKA 



2. AUDIO CD METHOD (Permanent) 
** Insert Audio CD 
** Press PLAY 
** Press STOP twice on remote 
** Enter 26604 on remote 
** Press ENTER 
** Take out Audio CD and Insert a DVD 
Credit: Myself via a DUAL Tech 

---------------- 

3. DVD METHOD (Permanent) 
** Insert a DVD 
** Let it play until you hear sound 
** Press STOP twice on remote 
** Enter 26604 
** Press ENTER 
Credit: Adam P. 

I have the same Kenwood unit and mine worked great for over 2 years.... I now get the same 05 error code whenever i insert any cds.... I havent yet been able to find anything about this on the net... I am about to take the cd player in for the extended warranty I purchased with it.... It is by far the best cd player that I have ever owned...............

Unit displays TOC error when I inserted two new cds I purchased.

Same problem here. It was every now and then it would happen but now its constantly. It aggravates me and I'm gonna have to buy a new deck because I don't know whats wrong

M-Error is a mechanical error and could have a multitude of causes. just went through it with a TAD-5160 unit where it was a small slip gear moving a tin lever to ingage the transport sled to insert or eject the disk from and to the carusel. You may have to take the unit apart and asess the problem. Harleysp.

i once had a panasonic dvd player which displayed the same code H02 and used the same drive mechanism as your player. this turned out to be a worn spindle motor and once replaced, all worked fine. you may well have the same fault. hope this helps?