What is the Sequence to restart kuds30fxss - KitchenAid KUDS30FXSS Builtin Dishwasher

Press the Cancel/ Drain cycle for a few seconds. The dishwasher should reset itself. See if this makes any difference. Also first turn the mains power to dishwasher off and back on.

it is likely the heater or thermostat are faulty. Try to run in short cycle like rinse which works on cold water.

Here's a link for the repair manual for your dishwasher:
http://www.appliancerepair.net/kitchenaid-dishwasher-repair.html
Concentration should be on Chapter 2 subsection 2-3 "No Fill"
Then go to Chapter 6; subsections 6-2, 6-3, 6-3a, 6-3b, 6-3c, and 6-3h for testing procedures on relays, actuator valves, etc.

take all the food out wash it down and if that dose not work freebeez

first ensure your machine is not set to half load, as this may only run the bottom shelf and not the top. also check the wather sprinkler rotor is not blocked. remove it and check the holes are free from debris.

i hope this was useful

See my problem and solution. Sounds like you, too, are having a problem with the main control board (computer chip that controls the dishwasher), which is apparently a common problem with this model dishwasher. The part can be found here, for $211 (tax + shipping), and they have a 30-day return policy in the event that it does not fix the problem. It's an easy DIY fix. Hopefully this helps!

Sounds to me like a plumbing issue. Might have to try another plumber.

Hello & Welcome to FixYa

Flashing clean light is reset by pressing two buttons in sequence 3-4 times, to reset your kenmore press these buttons in sequence:

High temp wash-heated dry-high temp wash-heated dry

Please get back to me if you have any other questions.

Kevin

First check Asus site for Bios upgrade.
Then use the available Vista drivers for sound, webcam and Card reader.
Normally the sequence for driver installation is as follows:
Install the chipset driver, restart
Install the VGA driver, restart
Install Sound driver, restart
Others can come in any order.
NOTE: Utility software such as a Fingerprint or face recognition software should be installed after the driver has been installed
Good luck