Where is reset button for thr mktubisushi tv,

Try unplugging the TV from the outlet or power strip. Hold the TV power button down for 40 seconds, release and then plug it back in to your power outlet. Power the TV back on with your remote.

If you want, you can do it auto program. Press the tv and enter button at same time one the lights stop flashing press the fast forward button untill the tv turns on or off whichever the opposite currently is. Once the tv turns on or off press thr enter button. If thr tv is now on try to work the volume. If the tv is off, try tufnung the tv in with the remotd. If the tv does neither yiu passed the code and need to repeat the process. I count the times I press the ff button so if I pass the code I can go fasger until I get to around where the tv turned on or off last time. his process works for most ddvices, some tvs may require pressing the ff button several hundred times to find the correct code.

check that ur video input on the tv is set correctly. you can do this by turning on ur theater system first , when u get ur sound grab the tv remote and select the tv input button or if u don't have said button try thr tv/video button untill u get a picture. ( this of course a suring that ur video cable is connected ) hope that helps

hi lianamoto to reset thr mototblur put in thr email and thrn put in fotgot password, Now the phone should send a link to reset the password to yout email that you use to set up your blur account in the first place. hope this helps.of not you can go to thr motorola website.

I’m happy to help further over the phone at https://www.6ya.com/expert/ronald_e152e07e272e4f27

Either a leaky TAC switch on the key pad or a bad Micro Processor.

Do a tv system over haul reset.Tries unplug,replug the tv an hour later.Go to the tv menu,goto AUDIO,go down to do the resetting,now the tv is back to factory setting.Go to the tv menu,than goto PICTURE,go down to resetting,to reset all the Tuner board setting,back to the factory setting.The audio,should be back now.Not,retraced from the speakers,wires back to the board connections,unplug,replug every connnetoins and replaced all the supporting components near the speakers wires are connected.

check your connection, then on thr front of the unit on the lower right side is a small panel, flip it down and push the red button, this will reset it, if it does nothin the unit is dead, call Directv and they will send out a new unit

As described in your manual, try doing a manual reset. Depending on the model you may have to remove the fascia to get at thr reset button.

if your tv has a menu button on it enter and try ot turn it off via thr front control buttons

From thr moment I turn my phone on: middle button > 1x down > select > 5x down > select > 2x up > select > enter pin (6 zeros if you don't know it) > select > top left key