Light blinks and won't turn on - Whirlpool GU2400XTP Built-in Dishwasher

Look Behind the triangle panel on the left side of the bike. Next to the battery. FUSES

These blinks to standby light are fault indications, called blinking codes. From the number of blinks occur at one time switch on, you can get an idea about the faulty circuit stage inside it. Count it. Visit this site. It has details about blinking codes to many brand televisions.http://electronicshelponline.blogspot.com/Pull up older posts there, either by its left side bar, or see it in Timslide option

Look at the blinking light count the number of times it blinks and go to google type in ps3 light blinking error code

Read this:

http://www.prlog.org/10506996-ps3-red-flashing-light-causes-and-solution-revive-your-ps3-by-fixing-red-lights-blinking-yourself.html

the green light blinking is normal if set has been unplugged--when set is plugged back it should blink for about 70 seconds and then go out--then you can try to turn it on---it is the DM unit inside the set booting up.

If the light just blinks and never stops you have likely bad caps in the DM unit---there are kits available for that.

The other possible reason is that so called reset switch may be bad--fairly easy way to find that out and it is more common than you would think, let me know if you have questions.

SD TECH

Blinking light usually is a error code if blinks a certain number of blinks and the place to begin is to look for a bad fuse or bad puffed up caps inside on the power supply board--place to begin.........

I have a wd-57731 The lamp light blinked orange. i replaced the lamp turned the tv on and the timer blinks green for one minute and then the lamp light blinks orange again. It won't turn on. Can you suggest anything?

3 blinks indicates lamp door is not on or has not been reinstalled properly. This also could mean the lamp door switch has failed itself. Try removing the lamp door and putting back on, if that doesnt correct the problem then I recommend having the switch replaced.

a suggestion: unplug set and try to turn on again; if power light blinks does it blink in a sequence?

3 blinks repeated will mean a problem in the Convergence area.

5 blinks repeated will mean a short on the 140 volt line.

These are the two most common error codes.

SD TECH

Check fob bat ...check here 2... http://harleytalking.com/login.php?do=logout&logouthash=1313501436-eb7a83064e08c13f62cc323a7bbce4a8d217cd8d