Lo batt blinks continously on Link 2000 monitor display

Suggest have battery tested.
Most thermostats cost more to repair than to simply replace them.

under your batt tray needs removed youll find a rubber hose goin to a vacume canastersee that it aint cracked or got a hole

If your monitor is blinking or flickering increase the refresh rate.

This generally means that there is a circuit error. You can try to reset the monitor by unplugging it and holding down the power button when you plug it back in. If this does not solve the problem the monitor will need to be serviced.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/benjamin_29adbb94bfb43281

check the connection to the cpu.fix the VGA cable connector.

Most common failure in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply, falied inverter circuits (blown fuse, shorted transistors, shorted/open transformers), bad lamps (poor solder connections or worn out lamps). You will need to open it up and inspect the inside, see example of failed Dell and other monitors to get some ideas what goes wrong: http://s807.photobucket.com/home/budm/allalbums
Post back what you see inside so we can guide you further.

sometimes you can bend out the battery holders to allow more tention on the batteries but thats only a temporary repair. a new thermostat is needed

Check your connector to your computer if that's good check the HOT if it's bad replace the HOT and flyback. Check the SMPS caps.

Hello,

OSD Unlock : Press and hold the [1] and [▼] buttons again for 5 seconds. The message “OSD UNLOCK” will then display briefly, indicating that the OSD image settings are now unlocked.

You will find that and other information in the manual located here. The above information is found on page 7.

Hope this helps. Please remember to rate this information.

Thanks

1. cpu problem. why because of there is no signal output from cpu to monitor. the led blinking means there is no vertical, horizontal signals from cpu to monitor.

2. your monitor connected to another system.

3. neck board dry points.

4. cheak the display cable. 13&14 pins are horizontal, vertical signals.1, 2, 3 pins , R G B , 6 ,7, 8 pins R G B ground ( coaxiler cable used , meshed wire is ground )