Question about Korg AW2G-Clip-On Chromatic Tuner

Open Question

When in pure 5th tuning for violin, the tuner only registers open strings, but nOT any in between! This just started.

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i adjust intonation on a peavey predator plus exp?


To adjust the intonation on a guitar you need the following. ..
a electronic tuner
and a small philip screwdriver

when you tune a string say low E you play the note open and adjust tell it's in tune
then to intonate play the low E at the 12th fret
producing a Harmonic, view the tuner it will be sharp or flat,
turn the small philip screw on the bridge adjustment
it only takes a small turn one way or the other so go slow
once the string is tuned at the harmonic note check to see if it's in tune played open, keep tuning and adjusting tell the strings are in tune open and at the 12th fret on all six strings
once intonation is set properly the guitar will sound better
really hope that helps?

Mar 15, 2015 | Peavey Music

1 Answer

How do I set the tuner to tune at different keys?


Good question, tuners can be simple and some are complicated
a basic automatic guitar tuner you would not have to do anything to the settings, just tune normal on the E string then slowly down tune to D most tuners are a little sensitive, so go slow
and one thing I always do is go lower than the note I'm tuning to then tune up tell it's correct, strings seem to stay in tune better
Hope this helps ?
and if you have time check back on my profile
I will be doing some video tips this weekend
showing tuning, and some basic guitar repairs
thanks for your time

Mar 06, 2015 | Music

1 Answer

Would like a parts schematic for a Bb400 gold tone bass banjo


This is a list of All the parts you need, I don't know about a schematic?

1 Maple Neck ? 1 11" wood rim ? 1 11" notched tension hoop ? 1 Flat head alloy tone ring (Optional bell brass available) ? 1 Resonator (not included in the open back kit) ? 1 11" Remo frosted banjo head ? 1 Arm Rest ? 2 Coordinator rods with hanger bolts (one longer than the other) ? 1 "L" shaped tailpiece bracket (may be attached to coordinator rods) ? 1 5th string nut ? 4 Guitar style tuners (planetary tuners optional) ? 1 Geared 5th string tuning machines ? 24 Shoe style lugs with bolts and washers ? 24 Hooks and nuts ? 1 Nut, pre notched ? 4 Resonator plates ? 4 Brass inserts (brass anchors that are threaded on the inside) ? 4 Resonator bolts (knurled on the outside with a Phillips screwdriver receiver on top) ? 1 5 string bridge ? 1 Gary Price style Tailpiece ? 1 Set of strings ? 22 Pre-cut (ready to install) frets ? 1 Truss rod cover (including three screws)

Mar 06, 2015 | Bass Music

1 Answer

Tuner Won't Acknowledge Sound


Before turning the unit on, press the calib/batt button to check the battery condition.
The Fender AG6 only responds when the strings pitch is within a certain frequency range. If the guitars tuning is not within that range or if your installing new strings, first connect the guitar to the AG6 with a cord that you know to be in good working condition and turn the AG6 on. Then starting with the low E string (the thickest one), loosen the tuning peg to a point well below the standard tuning for that string. Then slowly tighten the peg as you strike the string repeatedly. When the strings frequency, comes within range you will see the 6E light glow and the needle will begin to deflect. When the needle reaches zero it is in tune. Do the remainder of the strings the same way then go back and recheck each a second time. If you have a tuning fork, you can use it to tune by ear then re-tune and maintain it with the AG6
Remember to always stretch then re-tune new strings several times.
If the AG6 does not respond even after checking the condition of the battery and the cord that connects the guitar to the tuner, the problem could be inside the AG6 with a bad connection on the board. Try moving the cord as you strike a string that you know is close to being in tune. Again a tuning fork would be helpful.
~DrewWatk

Jun 10, 2013 | Fender AG6 Automatic Guitar Tuner

1 Answer

Hi, i have a acoustic guitar and i am trying to tune it but i do not know how to use the Matrix Chromatic Tuner SR-1050


Hi
Simply turn the tuner on using the power button. Play an open string note close to the tuner (no more than about 1/2 metre away) - for instance the low E on string 6.
The built in microphone will pick up the sound and, if your guitar is reasonably close to being in tune the led light labelled 'E' will illuminate on the lower scale on the tuner along with one of the three other leds to indicate whether the note is flat (b), in tune (green) or sharp (#).
Due to harmonics any or all of these three leds may flash but it is the one that is on the most that matters.
Adjust the tuning peg until the green is on constantly when you play the string.
Move on to the next string
Note - if the string is more than a semitone sharp or flat a different light may flash (e.g if the low E string is 3/4 of a tone flat the D light will come on).
If you wish to tune your guitar to another instrument that is not at perfect pitch (and perhaps cannot be easily adjusted - like a pipe organ) you can use the calibrate button to adjust the setting of the tuner. This temporary recalibration will be lost when the tuner is turned off.

Mar 01, 2011 | Matrix Auto Chromatic Tuner Sr1050

1 Answer

Is he tuner supposed to light up green when the string is correctly tuned?


Before turning the unit on, press and hold down the calib/batt switch to check the condition of the battery on the battery meter.

Then either plug in your electric guitar to the input side of the AG-6 or if tuning an acoustic guitar without electronics placing the AG-6 near the front of the guitar should work. You will not need to press a button to select which string you are about to tune. The AG-6 will detect it and the corresponding light will turn on when it is tuned within range.

Turn on the AG-6 and start by striking the low E (thickest) string while open. This is the number 6 string or 6E. Slowly turn the guitars low E tuning key untill the red LED below the 6E marking on the AG-6 lights up. Continue stricking the open string and turning the key untill the needle centers on zero and the 6E light remains on.

Repeat this for the open A string untill the 5A light turns on and the needle centers on zero.

Repeat for the remaining four strings, 4D 3G 2B and 1E, being careful not to over tighten and break them.

Tip: It may be a good idea once the low E string is tuned, to tune the rest manually, especially new strings or strings way out of tune. Then tune again using the AG-6 tuner.
.
If installing fresh strings you will probably need to stretch each string and re-tune, possibly several times, before they hold their tuning.

Feb 19, 2011 | Fender AG6 Automatic Guitar Tuner

1 Answer

The d string on my yamaha ev 204 electric violin has no volume w/ the volume is turned up . Any suggestions?


Hello, what a great violin to own, I am jealous. Each string on your violin has a pickup sensor under it. So, what you have are 4 sensors (one for each string) and the signals are then fed into your violin's electronics and mixed there to provide a wonderful rich sound. The sensor under the D string has a problem. I would look there first and in the electronics package last. The best advice I can offer is this, I also am a musician and play violin and 12 string ovation guitar. I have worked on both my instruments, unless you are very skilled in your knowledge of electronics and the delicate work on the sensors on your violin, I would take it to a craftsman (person) that has the skills to change out the sensor. Sometimes it can be a bad solder connection in the electronics, especially with the vibrations that an instrument causes, again, this would be for someone extremely skilled in instrument repair.

Dec 24, 2010 | Yamaha Ev 204 Silent Electric Violin

1 Answer

My guitar strings are out of tune. can somebody tell how to fix it/


download guitar tuner from below link
http://www.guitarforbeginners.com/onlinetuner.html
start from lowest string, tight it one thread at a time and with pick make sound, when guitar tuner sound from speaker and ur guitar make resonance, tune the upper one, repeat it for all and you are done
cheers!

Sep 08, 2010 | Miscellaneous

1 Answer

Need Korg GT-2 chromatic tuner help


well i hope you've figured it out by now, it's a really cool looking tuner and i love it. but if you are still having problems...
the switch on the left side: OFF, ON, LMP (ON with a little light so you can see in the dark)
The number and letters you see across the top of the interface indicate which string it is tuning to. 6E is the low E string (the thickest one) and 1E is the high E string (the thin one on the bottom of the guitar), i've seen many people get confused when they've tuned those two.
You can leave the tuner in auto and it will pick up what string you are trying to tune. but if you are having problems getting the correct string or whatever the case is, you can switch to manual mode. click the only button on the tuner and the specific string will light up on the interface.
If you press and hold the button, the tuner will go into flat mode, tuning all the strings flat.
once you have the right string and you're tuning it in, you want the needle to be centered.
that's pretty much it. enjoy!

Jan 05, 2010 | Music

2 Answers

No instructions for a yamaha erg 121 c electric guitar


i don't really know what instructions you expected, although you should have received something for the tuner and amp. I suspect that you are new to playing the guitar, as, I don't wish to sound disrespectful, you would know what to do! So first, and again I hope not to sound like I'm treating you like a dummy, plug the guitar into the tuner input. Or if It's a piezo tuner clamp it to your headstock. Most tuners are now automatic so it should pick up on the string you are striking.Repeatedly pluck the same string til the tuner changes colour, or flashes, or some other indication to tell you the string is at pitch. Repeat the above for all 6 strings.
Then plug the cable into the amp input, switch it on, and bugger about with the controls til you get a half decent sound. ( thats what the rest of us do).Don't expext too much from this package, it is budget level, but of quite good overall quality.hope this helps

Feb 05, 2009 | Yamaha Electric Guitar

Not finding what you are looking for?
Korg AW2G-Clip-On Chromatic Tuner Logo

Related Topics:

249 people viewed this question

Ask a Question

Usually answered in minutes!

Top Korg Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5686 Answers

The Knight
The Knight

Level 3 Expert

76046 Answers

Marvin
Marvin

Level 3 Expert

84625 Answers

Are you a Korg Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...