Where is the filter on model 300/500/DLX series

Have you checked for a kinked hose or plugged Garbage disposal - if new disposal make sure the plug is punched out

GO TO BOSCH WEBSITE PURCHASE DOWNLOAD SERVICE MANUAL eric992+

The code means that the water is taking to long to pump out
unsrew the pump filter at the bottom front right
have some towel ready to soak up the water
clean and replace filter
most times this fixes the fault
if it doesn't then check for a blocked drain hose or faulty pressure switch

Check for spares: Washing machine

Bosch vision 300/500 dlx series This video will show you how to change the pump washing machine Please remember to subscribe to our YouTube channel for all appliance tutorials
a 4 THUMBS rating is appreciated for answering your FREE question.
And don't forget to like us on facebook

Im getting an error e13 message and don't know what to do

I don't know your model, but the filter will be accessible without getting into the innards of the machine.

Look for something that looks like it might turn to unlock, then pull out located low down at the front or the back of the machine.

On my top loader the filter is housed in the spindle of the agitator post. Pulls out and reveals lint bag etc.

pull it out and see if there is any water in the bottom of you pan you more than likley have a leak somewhere.

Sounds like your water temp is too low,there is a heating element in the bottom that heats the water that is circulated,if it goes out it wont get hot enough to dissolve the soap,or clean your dishes.its not to difficult to replace.
Hope this helped.Let me know by rating me, or
For more help go to live chat.
lenwest

I had a Bosch DLX series dishwasher that had multiple problems.

First, it had greyish water in the bottom and pushing the power button did not turn on any lights. it had mostly finished a cycle, but not quite. my first thought was to clean it out. i sponged out all the water and removed and cleaned out the filters from the bottom which were all quite nasty. i found food, tiny bones, etc. I cleaned it out and that did nothing but was still probably the cause of the problem. I called Bosch tech support and asked about areset switch. There is none. They told me to switch off the circuit breaker for 30 MINUTES to reset everything. I did that which did not fix the problem.

I then examined the connector wires (connecting the electric to my house wiring) which are in the front under the kick plate, and discovered that they had MELTED! The wiring supplied by Bosch was stranded wire, and my home wiring is solid core. i trimmed the burnt stuff and reconnected it with new wire nuts. if this happens again i plan to disassemble the dishwasher's electric and replace the stranded wire with the good stuff.

That restored the electric and the lights and display. i then ran a test cycle and it seemed to just hum. my guess after googling a bit was that the float was stuck in the up position, and it was trying to drain. This site http://www.applianceaid.com/boschDW.html told me how to run the test mode.

"To start test program, press and hold both POWER SCRUB PLUS and REGULAR WASH program buttons, then turn unit on by pressing ON/OFF button. When program buttons are released, lights above them will flash. To end test program, press ON/OFF button."

The test mode tested out all functions which I think wound up reseting the float switch which actually fixed the rest of it.