WHAT DOSE THE REFERSH BUTTON LOOKS LIKE - Computers & Internet

First, I'm not a Pasquini tech, but I have worked on several similar brands.
* Most Semi-automatic machines will usually have the program button on the same as the stop button. Some will program all the groups at once or can be individually set up for different pours (shots)
* Holding down the program or stop button for 5-10 seconds will activate the program mode. Note that if you don't press any dosing buttons after 5-10 seconds the program mode will revert to normal mode. Some may cancel out the previous dose set up.
* Before starting, determine what you want a shot to look like. 1 oz, 1.5 oz, 2 oz., etc.
* Set up your portafilter with ground coffee. DONOT change the grind size once your satisfied with the QUALITY of pour (don't confuse this with the amount of the dose. This is handled with the programing of dose water.) Water is absorbed by the grounds depending on the grind size and some times the amount. Pods are different from loose ground coffee too.
* Load up portafilter and place measuring cup(s) under spout(s).
* Press program button and hold for 5-10 seconds. The button will light and stay on (some blink).
* Press the dose button for the appropriate portafilter you have mounted. The pasquini requires you to press the stop/program button once you have achived the desired dose. Other brands require the dose button to be press and held down until the amount of dose water is reached. Letting go button logs the amount in but only after pressing the stop button does it set.
* For other brands, you may need to set up all buttons prior to pressing the program/stop button to confirm dosing of all buttons.
* Remember to keep reloading fresh coffee grounds in the portafilter for each adjustment. Used (wet) coffee will throw out the water dose calibration.
Aloha, ukeboy57

PS; I found a good video from Whole Latte Love site:
https://www.youtube.com/watch?v=1NGN55nYBxQ

It looks something like a button battery with a mounting hole on either side.

refersh code problem

throw it away over rated ph

dile *#7370# it will ask for security code dile 12345 your phone will be formated

Login into safe mode and change the refersh rate from desktop properties

pls refersh cmos battery

Hi..
If you want to restore your code then go to setting & tap on master reset it'll not lost your data but refersh your phone to defult...
Otherwise go to setting>security>change password> & enter 123456 two times...

You need to install the graphics driver software for your motherboard ,which u can find on the driver CD ...
Thank You

check for account balance
check message centre number which is provided by operator
refersh switch on off...and send again