How to fix job concelled on ineo develop 164

replace cleaning blade

http://farbtoner.com/develop-ineo-c-200.html?language=en

need a developer Dv-116 or try to -menu quick setting << quick setting <> (service mode) go to function and press auto TCR adjust press ok or need developer Dv-116

Do not re-set you replace the developer. If you reset the copier will think it has new developer then will set voltages according when in fact the developer is old causing image issues and codes, replace the deveploer and run required procedures CLEAR THE COUNTER FIRST

try this site for parts first

Precision Roller Printer Toner Cartridges Parts and Supplies Office...

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Replace the developer after clearing counters and before running developer charge

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

sir
Have you replaced the developer??? Did you clear the developer counter??? Before you remove old developer. Did you run the required Developer Charge after new developer was installed???

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Have you replaced the developer??? Did you clear the developer counter??? Before you remove old developer. Did you run the required Developer Charge after new developer was installed???

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

You must press Utylity/Counter next open on screen admin setting. (Pass is 12345678) next network setting, IP setting and you can set IP address. If network (card, cable, switch or router) are OK you can print on your Develop. Driver you find on www.develop.de or http://www.konicaminolta.eu/en/business-solutions/support/download-center.html

main board problem