Green light blinks and cant turn tv on

all these sets have a boot up if unplugged.

If power is lost or disconnected when reconnected green light will blink for about 70 seconds (set is rebooting) and then go off allowing set to be turned on.

Questions?

I found this on another website, most likely it is your power supply capacitors.

1. Press the "reset" button and hold for 10 seconds .... Does TV turn on and blinking green light turn to solid green.


2. Unplug the TV from it's power source for various times, ranging between 5 minutes and 24 hours..... Does blinking green light continue upon plugging in the TV.


3. Disconnect ALL devices from the TV; DVD, Tuner, Cable Box, unplug the TV for various duration times .... Does blinking green light continues upon plugging in the TV.


4. Press Power and Menu buttons simultaneously and hold depressed for 20 seconds .... Does blinking green light continue to flash.


5. Press Power and Display buttons simultaneously and hold depressed for 20 seconds .... Does blinking green light continue to flash.


6. Insure that no front panel buttons are inadvertently stuck in an "engaged" position.

Diagnosis: If none of the above test resolve the issue, then the failure lies in one of the following:

1. DM Module Capacitors have FAILED.
2. DM Module is defective.
3. EEPROM Board failure
4. Power Supply failure.

This is cause of a power interuption. Try unpluging the TV from the wall, and waiting several min. Then plug it back up, wait serveral min again and the green light should stop blinking.Then turn it on.

hello i've just checked the manual for here is some information

None TV is powered off. Normal operation.

Green TV is powered on. Normal operation.

Green 1. TV just plugged into AC outlet.

Wait until blinking stops before turning on (approximately 1

minute). Normal operation.

2. AC just restored after power failure.

3. TV Rebooting after System Reset was

used.

4. TV Rebooting after power fluctuation

or receiving abnormal digital signals

from digital channel, or digital device.

5. You have begun the procedure to

update software from an authorized

flash memory device.

For detailed information, see the instructions that accompany

the authorized software update. IMPORTANT: Do not

use unauthorized software at any time.

Green TV just powered off and lamp is

cooling.

Starts to blink 30 seconds after turning off TV. TV can be turned

on before blinking starts or after blinking stops, but not while the
indicator is blinking. Normal operation. hope it helps regards shaun
Green TV powered off and auto-on timer is set. Normal operation. TV can be turned on at any time.

You have a bad capacitor. Location is 2074, this is a 25 volt 2200MF 105 degree radial cap! Have a tech check any other caps nearby as well! This is a good start for repair......PS no flashing allowed!

I would check the ballast assy and make sure it is good if that is fine check the color wheel

I UNPLUG IT AND WAIT A FEW MINUTES...THEN I PLUG IN THE POWER AGAIN AND IT WORKS

Check the lamp door (with green on) ,.. both green and red blink - bad lamp. Green off, red blinks..Try unpluging for 2 minutes and retry - if no different (sorry, call a service person).

disconnect the power cord overnight try it if ok change power cord cheers

The constant blinking green light means that the TV is not booting up. This is a common problem on this set.You need to remove the shield from the DM board (standing upright on the left where the DTV RF connector is)and inside you will see the four leaky capacitors (1000 MFD 16 VOLT)replace them,plug the TV in and wait 70 seconds for the blinking light to stop,then turn on the TV.The hard part will be removing the board from the TV(lots of screws and connectors,takes time)