Dishwashers Logo

Related Topics:

Fernando Rocha Posted on Jun 02, 2014

Why Whirlpool ADG-6558/1 IX stops sometimes the wash cycle after 15/30 min?

Whirlpool model ADG-6558/1 IX The wash cycle is sometimes interrupted after 15 to 30 minutes. I have noticed that when it starts to heat water - after opening the lid of the detergent / dishwashing tablet, the program stops and indicates END or the duration of the program. Maybe some moisture in circuits?

1 Answer

Dean Dahle

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Greenhorn:

A rookie expert who has answered 20 questions on their first day.

  • Contributor 34 Answers
  • Posted on Jun 10, 2014
Dean Dahle
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Greenhorn:

A rookie expert who has answered 20 questions on their first day.

Joined: Jun 10, 2014
Answers
34
Questions
1
Helped
6899
Points
34

Reset the panel by hitting normal-- heat dry NOT at the same time until all lights flash then push cancel and it should start. element is going bad

5 Related Answers

Anonymous

  • 2071 Answers
  • Posted on Aug 17, 2008

SOURCE: Subject is Bosch dishwasher SHU6800.

WHAT IS WRONG WITH YOUR DISHWASHER?

small_9_26.jpg For a detailed Dishwasher illustration, click below.

redarrow.gif Built in
Warning!To avoid personal injury or even death, always disconnect yourappliance from its power source--that is, unplug it or break theconnection at the circuit breaker or fuse box--before you do anytroubleshooting or repair work on your appliance. Also, because somecomponents may have sharp edges, use caution while working on yourappliance.

There's an error code on the digital display

It doesn't work at all
It cleans poorly
There's no water entering the machine
The water doesn't drain from the machine
It's noisy
It leaks
The dry cycle has problems
The door has problems
The cycle doesn't complete
I see an error code
The detergent cup doesn't open
The cycle times are too long

Ad
A

Anonymous

  • Posted on Sep 09, 2008

SOURCE: Whirlpool Dishwasher Model ADG 7560 Unit

found outlet pipe was kinked, stopping water flow

Anonymous

  • 8619 Answers
  • Posted on Feb 22, 2009

SOURCE: Neff S5433 Dishwasher - Detergent tablet not dissolving

Hi!

Please run the machine without detergent for 2-3 washes. Also try using a little hot water. Also, don't used cleaner and softener together but add softener on the last rinse.

VtToolMan

Mark

  • 704 Answers
  • Posted on Jul 31, 2009

SOURCE: Dishwasher 3 in 1 detergent tablet not dissolving.

I believe that the instructions for using these 3-in-1 tablets is to place it in the open dish detergent cup, rather than in the closable compartment, since the tablet needs to get doused by a lot of water in oder to fully dissolve and be effective in getting the dishes clean.

Since the tablets are designed to dissolve more slowly, they are able to be used for the entire range of washing cycles. If it's a constant problem and you don's have an open detergent cup below or next to your closed detergent dispenser, just toss it into the bottom of the dishwasher instead.

The reason that the tablet isn't getting dissolved fully is because the door is preventing the tablet from dropping all the way out and the door is shielding the tablet from quite a bit of water spray.

Another option is to take a look at your owners manual for the dishwasher and see if they recommend these all-in-one tablets versus regular powered detergent and liquid rinse aid.

Hope that helps and best regards!

exploreris

  • 176 Answers
  • Posted on Feb 14, 2010

SOURCE: Whirlpool dishwasher stuck on prewash cycle

the eprom memory is brocken,the main board must be changed.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Whirlpool integrated dishwasher model ADG 7460 Have run the engineer test cycle and it stops and drains water after 2 mins; start light blinks 5 times.

F5 or 5 times flashing.
Variable speed motor failure.

Reason:
- Connection between Spray pump (Variable speed motor) and control board interrupted.
- Frequency converteron Spray pump broken or control board defective.

= Check the power voltage on the motor. BUS: 5V DC, Motor: 230V AC

Reaction: Cycle stops, drain pump drains out,failure indication.

OR

F5 or 5 times flashing.
SPM blocked (MPH motor unit)

Failure condition:
- This failure is only indicated during the active test program
- The electronic detects an irregular deviation of the motor current consumption.

Reason:
Spray pump blocked = check pump housing
Short circuit in motor or wiring = check motor values

Reaction: After 5 attempts to reactivate the spray pump motor the cycle stops, drain pump drains out, failure indication.

Dado
0helpful
1answer

WHIRLPOOL ADG 6340 ix - At start and during the cycle water drains in pulses and for long time and water intake is in pulses and for long time. The cycle finishes OK but it takes long time, 30 min cycle...

since the water drain is on a float be sure there is no blockage of the screen drain area in the bottem of the dishwasher under the lower rack.the make some cleaner rinses to clean out the screen.
1helpful
2answers

I have a Whirlpool Dishwasher model no. ADG 6340 IX.The inlet valve is pulsing and letting in water on every pulse. It just keeps filling, over fills and trips elcb

Hello there and thank you for choosing fixya
This is a very common problem with these types of machines the water inlet valve has a solinoid for the hot and a solinoid for the cold that opens and closes the water on demand .
When they start to pulsate like this it is trying to close the valve but it cant this is normally due to the valve being clogged with debris or the valve is failing all together and simply needs to be replaced
So what i would do is first if you can look into the inlet valve with a flashlight and see ifit looks like it has stuff in it and if so clean it out and try it again if this doesnt work than you can assum that the valve will need to be replaced here is what the one of the valves should look like or close to it .
$50.60 Quantity:

In Stock
tbirdfan1_86.jpg

2helpful
1answer

Hi. I have a problem with my dishwasher ADG 6556.

If this model has the normal wash, and heated dry buttons there is a sequence of buttons to press to do the reset, which buttons do you have, reading from left, to right on the touch panel.
0helpful
1answer

Filling and running for 2 mins, discharging all the water then signalling that the cycle is complete Model is ADG 7460

This sounds like the heater is faulty. Try running the dishwasher on a rinse cycle- if this cycle completes as normal then this would prove that the heater has gone. If not please get back to me
3helpful
1answer

Adg 3962 IX showing fault code f2 with flashing

The machine has a switch inside that activates when a set amount of water is loaded.
If this switch then breaks (switches off) during the wash the machine assumes that the water has leaked out.
Run it through a couple of washes, check for a leak and see how it goes.
Hopefully it will be fine.
F2 indicates a flooded base.

Press and hold the start button until the start light goes out. (This resets the appliance)
Select a new programme and try the machine again.

If it comes up with a fault F2, take the panel off below the door and check for water in the base.
Be careful when you take the panel off, the exposed edges are razor sharp.
Drain any water in the base, reset and try the machine again and watch for a leak through the inspection panel.







May 24, 2010 • Dishwashers
0helpful
1answer

Whirlpool dishwasher stuck on prewash cycle

the eprom memory is brocken,the main board must be changed.
0helpful
1answer

Washer will not restart.

unplug it wait a few mins---- that should solve it sometimes these machines go in to a a "soft lock" condition
Not finding what you are looking for?

805 views

Ask a Question

Usually answered in minutes!

Top Whirlpool Dishwashers Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Cindy Wells

Level 3 Expert

6688 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Whirlpool Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...