Microwave cooking center

you will need to set the microwave to cook at 65% to 70%. this way the microwave only cooks 65 to 70 second out of 100 seconds giving the meat time to cook internally. just make sure the internal temperature reaches 165 degrees. before you remove it and and consume.

Hello

and/or circuit breakers, particularly in the case of recent power failure, and reset if necessary.


Unplug the microwave, wait 30 seconds and plug back in to the power supply to reset the microcomputer.


Open and close the microwave door firmly and press "Stop/Reset." Select a new cook time and press "Start."


Ensure a proper cooking temperature and/or time is chosen, as low cooking temperatures or short cooking times may prevent the microwave from heating food appropriately. Press "Power Level" to ensure the microwave is cooking at 100 percent power.


Contact an authorized service technician if the problem is still unresolved.

To cook brown rice takes about twice as long at white rice. Usually there are microwave instructions on the rice package.
If the instructions specify a certain power, like 1000W, you
can look on the back of your microwave or in the instruction
booklet to see what yours is.
Good luck,
genetuck

I don't own one but per the TastiWave Quick Start Guide (which can be downloaded as a PDF document), The wattage must not exceed 1300 Watts. In the Instruction manual and quick cook recipe guide (also a downloadable PDF document) it states that:
"The recipes in this booklet have been written for an 1100 Watt microwave oven. Please adjust your “cook times” accordingly. Microwave must have a revolving turntable and the interior
must measure at least 14” wide x 14” deep x 7 3/4” high".
I hope this answers your question ;-)

Your temperature sensor inside on the microwave need to rreplace. It maybe dirty or faulty. Bring your microwave to electronics technician to check it.

GE
Microwave Fault Codes Failure
Code Condition Check/Repair F1 Open sensor, will occur below 190F of cavity temperature within 15 minutes after starting convection, combination or roast cook Check oven temperature sensor for continuity. Replace if zero or infinite ohms F2 Shorted thermal sensor, will occur if a shorted thermal sensor is detected continuously over 5 seconds on convection, combination or roast cooking Check oven temperature sensor for continuity. Replace if zero or infinite ohms

Note: It will take a minimum of 5 minutes of convection run time before F1 or F2 code will be displayed if the thermal sensor is shorted or open. F3 Shorted key panel (touch pad), will occur if a shorted key panel is detected continuously over 60 seconds Replace key panel (touch pad) F4 Open humidity sensor, will occur if humidity sensor is detected as being open continuously over 5 seconds Replace humidity sensor F5 Shorted humidity sensor, will occur if humidity sensor is detected as being shorted continuously over 5 seconds Replace humidity sensor F6 Shorted temperature probe, will occur if temperature probe is detected as shorted continuously over 5 seconds Replace temperature probe ProbEe Open temperature probe, will occur if temperature probe is detected open, or not plugged into the receptacle If probe is plugged in and "ProbE" is on display check continuity of the probe with an ohm meter. If zero or infinite ohms, replace it

Probely needs new magnatron.

Most any standard microwave temperature probe should work, from places such as Wal-Mart, Home Depot, Lowe's, etc.

This code means you have a bad temperature sensor or thermal fuse, or a fault in the wiring harness to or from one of them.

You can usually find helpful exploded view diagrams and order parts by entering your full model number here: http://tinyurl.com/gv383