Put in new batteries status light blinks no forward or reverse

Your Dyson may not have been connected to the charger correctly when last put away.

Hi charge batteries & get them load tested ..U can buy a BATTERY LOAD TESTER of E/BAY cost aprox $36 this will give U an accurate reading on there condition,.3 flashe's unplug charger & turn key of & back on ..5 flashe's remove key push freewheel lever into freewheel & back into drive put key back & try it . Cheers

I would suggest running the fault codes but I would check the engine mounts for failure. In normal drive forward situation the reaction of the motor is on one set of mounts but in reverse the reaction is put on to the opposite side mounts

try pushing button and then put in reverse back up a bit and then put in drive see if it goes in quicker. put truck in nuetral befor putting into 4 low

You had better recheck your connections because the batteries are polarity reversed

Get new battery, I have 4 batteries, all will turn it on, get horn lights, sound. 2 do the exact same thing yours is doing, 1 runs about 5 min then starts into your problem, 1 is good and will run for about 20 mins.

Typically this is controlled by the status of the FWD/DND button and indicated by the button light.
button light off: Forward and Do Not Disturb off
button light blinking red: Forward on
button light solid on: Do Not Disturb on

The functionality of this button can be customized by the phone system installer. If the method outlined above does not work the status and activation of this feature can be accessed through the staion programminng. To use station programming press <program> then scroll through the features using the LCD screen navigation keys or enter the specific program number. To program FWD/DND the program number is 50.

Hi,
You have to click the red button on the wireless adaptor. A light will start blinking and then press the red button under your mouse.

maybe is the hard disk malfunction

If the status light blinks orange when you press a button, the iPod shuffle buttons are
disabled. Press and hold Play/Pause (’) for about three seconds, until the status light
blinks green.