HOW DO YOU PUT A HOTPOINT FRIDGE INTO DEFROST MANUALLY THAT HAS AN ADAPTIVE DEFROST BOARD?
IS THERE A PLACE TO GET REPAIR MANUALS FOR THESE UNITS?
THANK YOU.
Hi
Check
the back wall or floor of the freezer section for frost. Check the freezer (
evaporator) fan to see if it is running. Check the condenser coils under the
unit for blockage from dust. Check the condenser fan (under the unit) to see if
it is running.
If you have frost in the freezer there is a problem with the defrost system and
the freezer will start to warm eventually as well as the fresh food section. If
that is the problem you can check the defrost terminator, defrost heater/s, and
the defrost timer or adaptive defrost control If used on your unit or the main
control board if so equipped. These things usually require dismantling the
freezer and other areas of the refrigerator to be checked.
There
can be many factors for the no cooling factor: the condenser coils could be
blocked with dust, the condenser fan could be bad or stuck, the freezer fan
could be stuck or bed, the freezer coils could be blocked with frost because
the self-defrost system is not working or the compressor is not running because
of a bad relay etc.
Please
check this link to get a detailed idea about your issue:-
http://www.appliance-repair-it.com/refrigerator-not-cooling.html
Please
get back to us if you have further query else please accept the suggestion.
Thank you for contacting fixya.com
The newest defrost feature
in modern fridges is the electronic adaptive defrost control board. has one version..to
put this adaptive defrost style of fridge into defrost, short with a small
screwdriver between L1 and test on the adaptive defrost board, wait 3 seconds
and you should hear a "click" noise from the relay and the fridge will shut off
and go through a defrost cycle. .
557 views
Usually answered in minutes!
×