SOURCE: pentair intelliflo variable speed pumps
Extensive information available is available from Pentair. Owners manual http://www.pentairpool.com/pdfs/IntelliFlo4x160and4x100OM.pdf Quick start guide http://www.pentairpool.com/pdfs/intelliflovsQSG.pdf
SOURCE: We lost our password for
On the normal vs-3050, you need to reset the whole unit. You do this by holding all 4 speed buttons for 30 seconds. After thi, shut off the power at the breaker. let sit for 2 minutes. Restore power and all setting are reset. I cant find any information about the SVRS model, but it should work the same way.
SOURCE: SWAPPING OUT A HARD DRIVE
If I can assume you are swapping out the Control module on an intelliflo, there are no directions needed. Just remove the 4 screws from the top. Then it is loose and you can dissconnect the wiring plug. Reverse to replace the new one. Very simple. But if you need a manual:
http://www.pentairpool.com/pdfs/IntelliFlo4x160and4x100OM.pdf
SOURCE: Pentair IntelliFlo VS-3050 & VS+SVRS Variable Speed Pump -leaks from housing
Which part of the housing?
The back against the motor or against the strainer basket housing?
Parts break down for the Pentair IntelliFlo VS-3050 here.
If leak is on the back of the housing - shaft seal. Or if the leak is on the front the replace O-Rings #10 or #23 in diagram.
6,925 views
Usually answered in minutes!
The LCD on the intelligible model is poorly water proofed. In most cases it needs to be replaced along with the entire unit costing about $700. There is a YouTube video where they opened up the LCD and clean off the electrical board & contacts with alcohol on Q-tips but I have never tried it so I can speak for It.
×