Water standing in bottom - Dishwashers

water does not drain

This is because you have a problem with the diswasher pump and/or pump motor. There should NO water standing at end of cycle.

None. You have a problem with either your pump and/or pump motor.

Try draino first then take it apart on the inside bottom to see what might be clogging it.

you may not be leaking out the bottom. Your stand pipe may be clogged. If the stand pipe has a slight clog in it, the stand pipe will over flow, and the water "looks" as if its leaking from the bottom... These pump faster than your old machine, so the pipe will back up faster... hope that helps

You most likely have a stubborn clog in your kitchen drain. Try filling the sinks with warm soapy water and then letting the water drain while also turning on your garbage disposal. Sometimes the extra water pressure will help push the clog through.

Can be helped here:
http://www.fixya.com/support/t1928312-door_front_end_whirpool_duet_washer_will

where is the water is it visible above the filter plate or is it in the bottom of the sump
if its in the bottom of the sump thats normal it will always leave water in the sump

try pressing the cancel/drain button.Do you hear water draining into sink freely?? if not i would disconnect drain undersink look for a clog right there first

are you leaving it long enough to finish it's programme or are you opening it when the drying light is on as some dishwashers leave a bit of water in the bottom to help with the drying programme