Trying to replace the xerox phaser 6300 imaging unit and it will not release to change to replace with new unit

Soulvisitor

• 1113 Answers
• Posted on Nov 19, 2007

SOURCE: Xerox Phaser 6250

How Brave is Jan?

Doubt it be the fuser(100 000life), "just magenta dots".... fuser would be "all smudged" or "black marks" , "the print rubs off" , "paper is creasing or jamming"

Can prove it by stopping a print (open door) when paper is1/2 way threw machine, you need to stop it before it goes threw the hot bit, so you can tell if the hot bit (fuser) puts the marks on the paper.

Transfer roller one would expect to effect whole print Smudged/Faint,uneven density

It will be the imaging unit ( 30 000 pagelife Ouch$ ) or possible leaking toner (if aftermarket)

Remove imaging unit and inspect film you should find image of lines, dots are usually chips or sticky stuff on drum surface, carefull no oily human fingers on surface please.

When stopping machine mid print and perfecting your timing, pull out the imaging unit and look at replica of your print notice if marked and where.

Hope this helps

SOURCE: Phaser Imaging Unit install error

Worked like a charm! Thank you for the detailed information. The step by step instructions were right on target.

SOURCE: Is it possible to reset xerox phaser 6110mfp

The image unit can be reset.
This is done by use of a small program that Xerox certified engineers use. The process is really simple and only takes about 30 secs, if you have access to the program ( I do... :) ) It can also be used to reset transfer belt life etc ....

SOURCE: Xerox Phaser 7300 color misregistration

Apparently, turning the unit off for 30 seconds, then back on will force the Phaser 7300 to do a color alignment procedure (according to Xerox support).

Then, if the problem persists, you are instructed to follow a very detailed troubleshooting procedure which I will leave with you in the following link:

Xerox Phaser 7300 Misregistration Issues

I hope this helps!

SOURCE: Xerox phaser 7760 saying "non-phaser imaging unit"

There is a snippet on the Xerox website to solve imaging unit recognition problems, link below. http://www.support.xerox.com/support/phaser-7760/downloads/engb.html?operatingSystem=winxp&fileLanguage=en_GB Usually this problem only occurs if the NVRAM has been reset or the engine board has been replaced without backing up the NVRAM. You can download the snippet to your printer through Centreware or by downloading the 'File Downloader' utility from the same page above.
Hope this helps.