Camera to pc

Videos recorded on one camcorder very seldom play back in another, due to the internal codes put on the tape by the original machine.

Hi, kindly download it here : www.panasonic.com/business/provideo/support/fcphd.asp
www.nodevice.com/driver/.../Panasonic/Digital_Cameras.html
www.givemefile.net > ... > Camera & Foto > Digital camera

Regard, Jay

You could try using a card reader to upload the videos to a folder on your desktop.

hey bro u know all the cables n the battery charger? u take them ntake the battery outta the camera, put it on the charge, put the battery that connects by cable to the charge in the camera, then plug it all in. should work for ya

take of the memorycard from camera and just put your sd-card to the memorycard slot and open it from my computer. and if you dont have one just connect camera to computer with cable

i have uploaded the driver here:
http://rapidshare.com/files/151262301/Driver.rar.html
un rar and install it on the computer.
when you are done installing the driver proceed with the movie transfer as follows:

1- conect the camera to computer
2- open moviemaker program
3- choose option - capture from video device
4- You will have a choice of devices depending what else ic connected - choose panasonic dv
5 -at the selection screen choose - best quality for playback on my computer
6 - start recording

get a dv firewier cable put your camcorder on playback ,it should work

Most likely you are connecting the camcorder to the PC via USB. In that case the video most likely cannot be transferred due to the fact that this is a master-slave (copy and paste) interface. In this case you would need a peer to peer (streaming) interface to copy from the miniDV tape - which would require a DV cable. The camera may have a 4-pin, but your PC might have a different configuration - usually also 4-pin or 6-pin. When you find out, you will need to get a 4-pin to X-pin DV interface cable that is OHCI compliant and you should be set. To capture the video, put the camera in playback mode and use whatever software you prefer - MovieMaker works well. Good luck.

. Take out the tape - AND TURN THE CAMERA POWER ON
2. press the menu button (near the viewfinder)
3. Use he wheel on top next to the viewfinderto scroll through the choices
4. Choose "display setup" by pushing the wheel in
5. Choose "C. Rest" by pushing the wheel in
6. Turn camera off
7. Next time you turn camera on y ou should be able to view tapes and record.
IT DID NOT WORK THE FISRT TIME SO I PUT MY FINGER IN TO TRY TO GENTLY PUSH BUTTON WHEN I TOOK THE TAPE OFF AND THEN TRIED SOLUTION ABOVE AGAIN, AND THIS TIME, IT WORKED. BUT PLEASE DONT INSERT YOUR FINGERS IN AS I DID TRY THE SOLUTION 2 OR THREE TIME IT SHOULD BE OK, HOPE THIS WORKS FOR YOU

The usb is only used for the still pics and for the webcam. You need a DV cable to upload vid.