Oyster pram Replacement handle bar

Hi Vicky

Could you please advise if you have a Quinny or an Oyster product

Where do I get a replacement bumper bar for a emmaljunga buggy

A replacement hand grip for bar for a graco pram.

When folding the Vibe some important things to remember are that the handlebar must be in the most upright position (perpendicular to the ground), nothing can be below the rear axle level (ie. lift the basket up above this) and the front single wheel should have the side with the attachment bar on the outside.
The fold locks will not engage if everything is not in the correct position. If everything is in the correct position the fold locks will easily engage/disengage. If everything is NOT in the correct position the fold locks will not engage and should not be forced.

Folding:

1. Put handle bar in upright position.


2. Undo the side lock clips. Then you lift the red lever on the side to start the fold. Fold so that the pram front wheel and handle come together.


3. As the pram folds ensure basket is above rear axle and the front wheel has the attachment bar on the outside.


4. When the pram is fully folded you can fold the side lock clips back in place.

Try pram restoration. Silvercross heritage.

Hi,

To open the Frog, follow the steps below:

Stand behind the folded stroller, ensuring the handle is on the top of the stroller.
Bend down and place your hands on the handle bar, DONT lift the pram, make sure it stays on the floor.
Push the white button on the inside of the left hand side of the handle bar.
Pull both triggers (located inside of the handle bar) toward you and lift the handle up.
Stand up-right, and place your foot onto the bottom of the two axles which you can see in front of you (make sure that you have your foot on the axle which connects the two small swivel wheels).
Whilst you are standing, with your hands on the handle bar and your foot on the axle, push the axle out with your foot away from you and slightly upwards. This should open the chassis up-right. Please note that the chassis will appear to be unstable and move, this will stop the minute that you click on your carseat/carrycot or seat unit.
I hope this helps.

Hi,

I find that the best way to do this is the following;
Make sure that nobody is standing behind the pram (expecially small people!)
Make sure that the seat unit is raised.
Stand to one side of the pram, bend down and with both small black plastic buttons, push inwards (so that they are going toward eachother)
The back of the pram should fall to the floor.
Where the childs back of the knees are, lift up the fabric a little and grab the black metal bar, then lift this up and the pram should collapse nicely. You should have a ******** the handle bar with a popper on to secure this shut.

I hope this helps.

Hi,

To fold the Mutsy Urban follow these steps:

Stand slightly to the left of the pram, but have the handle bar (with button depressed) in your right hand. Have your left hand on the black cuff (on the left hand leg of the chassis)
In one movement, push in the button on the handle (with your right hand) and move downwards, whilst pulling the cuff upwards (with your left hand). Do this quite firmly and the pram will then collapse. Make sure that the handle is in the lowest position after folding, ensuring that the pram is as small as possible.

I hope this helps.

hi bex_901. you can contact the retailer where you bought thestroller. you can also email silver cross about the new handle for your pram.surely, they have an available replacement for the handle. please check the link iprovided below. thanks for using fixya. good luck.

https://www.silvercross.co.uk/contact/spare-parts/

You should purchase your accessories direct from www.Bugaboo.com
email: [email protected] or call 1-800-460-2922. This way you can make sure that you don't void your warranty.

Good Luck! from Moms Just Know