A size 16 needle seems to be peeling the thread back what is the problem
SOURCE: brother xr-65 bobbin problem
insert the bobbin so the thread comes out in the middle a away from you, hold the thread end push the bobbin down with with your finger, and pass the thread securely through the thread cutting groove
SOURCE: while sewing the bobbin case moves, wheel locks up, needle locks
Im not sure if this will help but thought I would pass it along. My Pfaff 6122 tells me to check bobbin for thread unrolling clockwise before you place it back in the machine. I had mine turned to un roll counter clockwise, this is wrong, the bobbin will fall out when you pull on the thread while you are holding it in your hand. You may just keep putting it in backwards. Hope this works for you. J.R.
SOURCE: how to operate a Brother Compal DX
This -->link<-- is the Quick Set-up Guide for your machine.
This -->link<-- is the complete Owners Manual for you machine.
It sounds like a threading problem to me. it is covered in the Quick set-up and the Owners Manual
Hope this gets you sewing again
Thanks for using Fix Ya, please take the time to give this solution a Fix Ya rating.
clarkco
SOURCE: NEEDLE KEEPS COMING UNTHREADED WILL NOT CATCH IN FABRIC
Make sure you are threading the machine correctly and it has the proper tension. Also check the bobbin the thread has to go thru the little lash
SOURCE: Thread Breaking On Brother Sewing Machine
if thread is good quality you may have a sharp groove in your needle plate hole from needle breakage. if so, polish with emery tape.
scott
51 views
Usually answered in minutes!
×