How to hook up equalizer to the amplifier

It would go to audio out ports.

There are a number of amplifiers in the TA series, but the connections are basically the same.
In your system, the amplifier serves as master control. How do you know? Look for the component that offers input selection -tuner, cassette, CD, video, phono and probably auxiliary. Every other component plugs into and is controlled by the integrated amplifier. For example, plug the tuner wires from the tuner output to the amplifier input marked "Tuner." To use the tuner, just select that input from the front panel. Same with all the other components.

On the back of that unit will a bunch of RCA jacks for left and right channels. Take the hook-up wires, usually RCA cables with colored plugs on each end, and connect the OUTPUT jacks on each separate component to the INPUT jacks on the amp. Power may also be controlled from the amp. On audio plugs, red is right and white is left. Keep the polarity constant as you connect each component. Connect the speaker wires to the speaker outputs, usually spring clips or screw terminals on the amplifier end and the same on each speaker. The DVD video cable will have three wires: Yellow, red and white. Yellow is always video. It may also have a little round video connector for S-VHS which provides a much better picture when using DVD.
Select your desired input and enjoy the show. Service Manual free download schematics datasheets eeprom bins pcb...

Bog standard TT connected to a bog standard receiver. Hmmm.

I cannot figure out where you have the equalizer placed (or why, but that is another topic).

What exactly is beeping?

sound source out(dvd-cd player)-------------to teac eqa-5 in-----------------teac out---------to amp line in.

sound source(dvd or cd player)out ---------to eq in------------eq out ----------to amp line in(or receiver tape in)

sound source(dvd or cd player )out-------to equalizer in---------equalizer out---to receiver or mixer.

It can be downloaded here: http://esupport.sony.com/US/perl/model-find.pl?mdl=seq-711 Dan

You can't wire an equalizer to this amp unless you only want to equalize one source, because it doesn't have a tape monitor function.

OK, this is pretty easy to do. First connect your leads from the component outputs(i.e., tape, cd, phono, etc) to the recievers corresponding input for the device. Then connect the recievers outputs to your equalizer, if it is a seperate eq. Then the outputs of that to your amplifier, then your speakers to that. Be sure all of your wires are connected with the proper polarity. These instructions may be a little different for your exact setup but basically follow the same order minus any device you dont have.

For all intents and purposes, you can't. The STRDA3200ES has no tape monitor and it has no main out/pre in loop. Sony quit selling the SEQ711 and all EQs qfter they quit making receivers with tape monitors.

The 3200 has a tape out and in section, but it is not a tape monitor. Tape Monitoes allow us to select a source (CD, DVD, Phono, etc.) and send it to the tape deck, then listen to the tape deck. The tape switch on the 3200 et. al. takes the sound away from the source (CD, DVD, Phono, etc.) when we select Tape, so there is nothing there to equalize.

A possible solution exists, you can come out of the front pre outputs and go to the EQ in, then take the EQ outs and go to an outboard power amp. A possible drawback is that most seperate power amps do not have the fullness or detail of the 3200. You would have to rewire the speakers every time you wanted to listen to surround sound.

A second problem is that the SEQ711 does not have the same lack of distortion (phase, TIM, and THD) that the 3200 has. The EQ in the 3200, once you get used to it, may prove to be superior sound.

That's my 2 cents.

John Wheeler, former Sony ES dealer for 2 decades.