Eror 021 electrolux w455h

My friend's aunt makes $92 hourly on the laptop. She has been out of a job for 10 months but last month her pay was $15,000 just working on the laptop for a few hours. go to this web site and read morego to this site home tab for more detail I work through this link, go to tech tab for work detail......GOOD LUCK...www.cash.hiring9.com

To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin. Then, restore power.

Check the cable loom is not damaged and is connected correctly.

Hi! If you mean error F35, this error code indicates an analog pressure sensor error. This sensor is the component that detects water level in the washer tub.
F35 error code can be caused by a problem with the air pressure tube between the bottom of the washer tub and the analog pressure sensor.

Family error code E40 is visible to customers and (could be E41,E42,E43,E44 and E45 only visible in service mode) means problem with open door or door interlock.
I suggest rapid reading alarm code when appliance is in normal operating mode (e.g. during the execution of the washing
programme):
Press and hold down START/PAUSE and any of the option buttons for at least two seconds: the LEDs initially switch off, and then display the flashing sequence corresponding to the alarm.
The alarm sequence continues as long as the two buttons are held down.
E41 - Door open
E42 - Problems of door closure
E43 - Interlock power supply triac faulty
E44 - Door interlock sensor faulty
E45 - Door interlock sensing circuit triac faulty

Possible causes:
Door interlock faulty, wiring faulty or PCB faulty.


Dado

I sincerely hope that it will help to you!








Dado

Hi, you cant go wrong their both stihls. The 021 is a more powerful saw and the 017 is lighter, so it all depends on your intended use. Regards Phil.

Press

Function
7
monitor slowly 4 times
*
6
scroll down to SHIPMENT SET
set
2

wait for the fax to initialize and come back to READY

For the 021...on the muffler, there is a spark arresting screen, this is to prevent sparks from coming out of the muffler. It is common for this screen to become clogged with carbon from the engine. You will need to clean/replace this screen in order for it to run correctly.

here is the manual


http://service.us.panasonic.com/OPERMANPDF/UF585.PDF