Why only one side of oven burner will stay lighted fgf326asf

Whirlpool Gas Oven Will Not Stay Lit - Appliance Repair Forum

forum.appliancepartspros.com/oven.../482851-whirlpool-gas-oven-will-...

Jun 20, 2012 - 2 posts - ‎1 author
My Whirlpool gas oven will light but not stay lit. It has a glow plug igniter that heats up enough to allow the gas valve to open. Once the burner ... oven lights, but does not remain lit
10 posts
Feb 19, 2013
Oven does not stay lit
10 posts
Jun 19, 2012
Oven will ignite but will not stay lit
4 posts
Aug 3, 2010
Gas Oven won't stay lit
10 posts
Mar 25, 2008
More results from forum.appliancepartspros.com

If this is the design that the oven will click to light they generally will preheat but shut down once they go to standard bake. The oven will try three times to relight but then shuts down and will not try to light again until you reset the oven. If this is the case the oven burner itself is usually the problem. the burner comes with the electrode.

burner wont stay light

Hi,

Here is a tip that I wrote about the problem of the cooktop light staying on.

Oven Hot Surface Indicator Light stays on

heatman101

The stove Frigidaire Mod. FGF326ASF give an F3 error don't have manual instructions, could you tell me please what that means

g.e oven model # jbp3wb4ww burner light stays on when burners are off

Hi, it could be your, electric heating element and oven burner gas valve. both are located in oven burner compartment, remove last bottom panel, locate oven burner, the valve that feed gas to burner, has two wires connected to it, that's oven valve could be faulty, also look on side oven burner, you will see electrical heating element, could also be faulty, it's better to replace both oven valve and element, that's the most common problem, but first check oven thermostat, that's knob you turn to light oven, if thermostat o/k, then it's your oven valve or heating element, (used to ignite oven burner) or call a mechanic, good luck.

Hello jaronwayne
Welcome,

That range does have sealed burners.
Are you sure it has a pilot light and not Electronic ignition?

Where I live , if we call public service they will come out for free and light it for you!

I'm checking that model and I'll get back to you!
Huuum

I HAVE THE SAME PROBLEM WITH MY GE GAS RANGE. THE PILOT LIGHT IS ON BUT WILL NOT IGNITE THE BURNER. WHAT IS THE PROBLEM. LINDA [email protected]

One of the Ignitor/orifice assy.,electrode is bad expecially the one your wife have to light.The circuitry is ok,but change that bad ignitor/orifice assy electrode.
Part number is Item # 833121: check it out @ www.repairclinic.com