Philips mixer HR2094 - Philips Blenders

Kitchen appliances will and always will be an essential part of our life. Whether you are a culinary chef our a Permanent house chef :P Hand Blender, Food Processor, Stand Mixer and juicer mixer grinder these appliance will always be a part of your life. With these appliances you can tackle various kitchen chores with an ease; saving you an ample amount of time.

here you can know more

KitchenAid 6 QT Mixer

Hi,
One Philips' site for your blender it says Parts and Accessories and you can click the link to ask them directly.

http://www.p4c.philips.com/cgi-bin/cpindex.pl?ctn=HR2094/00&hlt=Link_FAQs&mid=Link_FAQs&scy=NZ&slg=ENG

I would go online to the manufacturer. You might also try an appliance store that handles mixers

You need to replace the plastic lift lever on the crank shaft hidden under the motor housing up inside the pedestal. Put it upside down on a towel and undo the 4 large philips head screws holding the pedestal to the bottom of the motor housing.

Remove the planetary and see if the noise vanishes, if not then you will need to open up the gearbox. It could be the pin retaining the fuse gear or maybe even the fuse gear itself failing. It seems unlikely though as you were only whipping cream and there is no effort in that.

Click on link or copy and paste in your browser: http://www.manualowl.com

Is it getting hot when you operate it? If you run a mixer for a long
time, the motor will get very warm. On the older units, when the
motor overheats, the various parts of the motor and its container
may start to melt. Mixer motors are not designed to last forever and
a replacement motor may be available from the manufacturer.
Another way is to purchase another similar mixer as you can on
eBay and swap parts.

YOU DO NOT NEED TO ,TO CLEAN MIX WATER AND CLEANING FLUID AND BLITZ THIS UNTILL CLEAN.

Leaking of oil in a stand mixer is not necessarily indicative of a large problem.

Kitchenaid stand mixers are overpacked with oil to last the lifetime of the motor. If the motor sits idle for some time (is not used), the oil may begin to drip from the gears and settle. Oil leakage may primarily be seen from around the beater shaft or planetary action.

A stand mixer can lose up to a 1/4 cup of oil before it needs to be serviced.

It is recommended to run the mixer on speed 10 for 2 minutes in order to redistribute oil back into the motor. In order to prevent future occurences, this is recommended to be done every 3 weeks if mixer is not being used.

KitchenAid Turbo Beaters - Stainless Steel
Model: KHM2B

$14.99

Features:
Replacement or Extra Set of Self-Cleaning Stainless
Steel Beaters Mix Cookie Dough Easily.

Turbobeaters fit only Hand Mixers manufactured since
September 1997.

If you have a model produced before 1997 please call
the KitchenAid Customer Satisfaction Center at
1-800-541-6390 with the model and serial number from
your hand mixer for further assistance.