Nikon d60 shutter release error

Your camera error is mostly like motor (aperture control unit) failing cause 90%, or 10% would be actually shutter unit defective.

It is nothing to lose to try this:
1. Remove the battery (the charged and good working battery),
2. Switch the power to ON position,
3. Press the shutter button for 5 seconds.
4. Switch the power to OFF position,
5. Insert the battery,
6. Switch the power to ON position,
7. Try to take a picture.

Please post the result here.

error shutter press release button again

This is an indication of a shutter issue. Contact Nikon for support.

Hi, to solve need to replace : sq base plate unit. Greethings

Hi
The error is with the shutter release button and the unit has to be taken apart....Get it repaired by Nikon it is a common problem with these units.
Thanks for using FixYa
Have a Nice Day

Turn camera on. Hold & press the 2 dotted button, [info] & [+?]. This will reset your camera. It ahould work again.

Press the shutter release again. Take out the battery and put it back in a while (1-2 min). Reset the camera with the reset button.

If this doesn't work, take it to the Nikon repair.

Remove the battery and let the camera sit for a few minutes. Reinsert the battery and turn the camera on. If the error persists, then consult with a Nikon-authorized service representative.

Locate the button behind the shutter release button with the green dot next to it. Locate the button at the back lower hand side of the D60 with the green dot next to it. Press both buttons at the same time.........This resets the D60 to its original settings and should resolve the problem.....