Trouble tuning in empty dtv channels

most sets its done in the setup menu--select if cable or antenna and then select auto program, set will scan and store all available channels it can find.

Make sure you are set to cable if you are using cable, or air ( DTV ) if you are using antenna.

I am having the exact same problem with my 47ZV650U, what was you solution

Hello
First of all reset the TV. for that

press and hold the POWER button
on the TV control panel for 5 or more seconds to reset the TV.
Then connect the TV tt any source like outdoor areiel or cable box etc, select the appropriate input, and retune the TV. First of all, connect it to an external antenna, and set it to autotune.

• You must configure the ANT/CABLE input source before

programming channels (-left-hand column).

• If the ANT/CABLE input signal type is set to Cable, the

automatic channel programming process erases channels

that were previously programmed into the TV's memory.

• If the ANT/CABLE input signal type is set to Antenna, the

automatic channel programming process adds newly found

channels to the existing set of programmed channels (and

does NOT erase channels that were previously

programmed into the TV's memory.) To remove an Antenna

source channel from the memory, you must manually delete

it.

• To tune the TV to a channel not programmed in the channel

memory, you must use the Channel Number buttons on the

remote control.

• Programming channels when the ANT/CABLE input is

configured for Cable will take substantially longer than when

the antenna input is configured for Antenna. This is normal;

however, once channel programming is finished, you should

not have to repeat the programming process again unless
your Cable TV service lineup changes significantly.
Find out the received channels are clear or not. If they are clear, your TV is perfect, and the input device you connects ot the TV is faulty. OK.

Hi,
Change video source by pressing Input button and select TV, make sure antenna is connected in RF In jack in tv then go to Tuning menu and select Auto Tuning/ Auto Scan option, tv will tune and store all available channels in memory.
Let me know model number of tv if you have additional question.
Thanks.

What analog channels?All channels are now SD or DTV.Ur scanning run up to 1 to 67 right.That are correct channels scanning.

go to menu put it on dtv scan channels/if not its aerial

what are you trying to do ?
if your trying to re scan your channels then go into youe setuo menu and rescan channels in cable mode if your on cable or antenna select air

Does it work with a DVD or VCR?
How is it connected? With a Coax cable or a an RCA component cable? Check that the correct video source is selected (The one associated with the input you are connected with) or that you are tuned to the correct channel on the TV if you are using the coaxial cable to connect. Could be channel 3 or 4 but I have seen them set for channels like 73.