Where Can I buy Polar FT7 Watch Band - Polar Electro POLAR FT40 Heartrate Monitor Wristwatch

Language settings should be specified in your user's manual.
See General Settings, Page 12-13
Read it. If you don't have one, download it from here

http://www.polar.com/e_manuals/FT7/Polar_FT7_user_manual_English/manual.pdf

See video

Polar FT 7 Heart Rate Watch review

Polar FT7 Heart Rate Monitor


Polar FT7 Fitness Heart Rate Monitor HeartRateMonitorsUSA com Polar FT7 Review 2015 Best Heart Rate Watch

Turn the watch over and look on the back of the watch near the wrist band. The serial number is the rather long set of numbers you will see there. You can't miss it. If you see what look like zeros or letter O's, they are zeros, not O's. I have the same watch, and that is your serial number.

You can get replacement band on amazon, click here and take a look Amazon com polar band replacement. I hope this was helpful, have a nice day

This heart rate monitor has a generic flaw with the sensor. The touch sensor fails after a few months of use. It is not a battery issue. Return to where you purchased it. Buy another brand. All of the drug stores carry this watch which has an abnormal return rate. The sensor fails after a few months while the watch function is fine. Seems like planned obsolescence.

You have to remove band in order to fit caseback back onto the watch. Insert pocket knife blade between band and case lug and pry inwards. This motion should release the band. It will be a lot more difficult to fit the band back on and you will probably need to buy springbar tool. Rate me plz.

Many people replace their own batteries but some of them have problems with replacing the backs and finding (for some unknown reason) the watch no longer works!


I advise you to take your watch to your nearest authorized dealer and ask them to do it for you.

You can get into difficulty replacing batteries and it is not worth the risk for the small cost saving in doing it yourself.

This is really easy to do yourself. Get a CR1632 battery, unscrew the four screws on the back (dont tip the watch as there is a small spring in the watch), unclip the metal band holding in the old battery noting the way 'round the battery is in (minus side up), pop in new battery and push clip back down, when re-fitting the back make sure the spring mentioned earlier lines up with the white sticker with a hole in it on the inside of the watch back, screw down the back. After you have re done all your settings you may need to re-aquaint the watch with the strap, to do this put on the watch and strap, set the heart monitoring going, bring the watch up close to the 'Polar' logo on the chest strap until the time is displayed, should now be all set up.

Andy

I don't know this watch in particular, but I know there are two main types of bands. Coded and non-coded. The S120 uses non-coded. That means you can use possibly any band on the market. Bands I know are compatible: Sigma and Ciclosport. The Polar bands are sealed, so you can use them while swimming. That's not true of the other two I mentioned - but the upside is you can replace the battery yourself once it wears down. You can probably get a replacement band from Polar directly, or buy a cheap knockoff elsewhere.

Usually it's a problem of battery get it replaced it should fix it

Here is the link to the user manual for your watch; http://www.polarusa.com/manuals/AXN300.pdf Check page 9 - you have to re-enter these basic settings after removing the battery, this may clear the error message although i was unable to confirm this from the manual. contact polar on; http://www.polarusa.com/default.asp and you can find a service centre who can check your watch, all the necessary link software downloads etc. Hope this helps :)