Replace the sevice module - HP Officejet H470 InkJet Printer

You must have the control module scanned for fault codes to see why it is on.

234.(11101010) Phase 6 - Lid Lock Open Circuit Check Harness to Lid Lock and connections at the Motor Control Module and lid lock ends.
Primary Fault: Connector to the harness. Either end could be at fault.
Action: Replace Harness.
Secondary Source: Lid Lock has failed to be activated.
Action: Replace Lid Lock housing.
Tertiary Source: Motor Control Module has not responded to the Lid Lock being activated.
Action: Check the lid has a Tang and is fitted correctly to activate the Lid Lock. If this is all in order, the Motor Control Module must be at fault and needs to be replaced.

That would be your computer system trying to tell you that there is a malfunction in your traction and stability control system. You will have to access the computer data in order to find out the nature of the failure and to diagnose the problem.

change the ignition control module or crank sensor

The “self test” on the monitor displays when not plugged into a computer. This means that it’s working. The LED error code 4 means the video subsystem has a problem. Either your video card is bad or bad memory module. Try reseating video card and/or memory.

Requires sevicing. New camara module & or camera activation activation switch.

my mashin bizhub is err cod c03ff modul 210

The PCM will be to the right side of the steering column where it comes through the firewall as you look under the hood. there will be 2 wire looms, one is the back side of the fuse box and the other is the PCM.

your prblem will be in motherboard or in power pack module-start to change powerpack module first then motherboard second- or pass it to good sevice center.