I cannot make my Fuji FinePix camera come up as a removable disk on my PC, I erased some pics from my SD card and need to recover them but the camera only shows up as a camera and I need it set as mass media, any ideas?
The camera cannot be used as a card reader. You'll need an actual card reader to write to the card. Yes, it's confusing. You can read the card without a card reader, but you need a card reader to write to the card.
SOURCE: no software for fuji finepix
go to the link below for the driver, you dont need software as you can explore the camera in my computer and copy then paste the photos, but windows may come up with picture viewer when you connect the cam up to the pc
http://www.fujifilm.co.uk/consumer/digital/digital-cameras/legacy-cameras/finepix-a204-zoom/support
SOURCE: my fuji finepix z10fd won't turn on. I bought a
When ever any kind of unit, camera or other wise will not turn on, then there are all kinds of problems which could cause this. It could be in the battery circuit with something wrong or disconnected. It could be in the switch to turn on the unit. There also could be a number of other things which could be at fault all of which could cause the camera not to turn on.
If there is some thing which happened in the past such as an impact, water getting inside the camera, or from being dropped, all of which could cause trouble.
My suggestion is to sell it on a site such as Ebay as parts, or have it looked at (if it is worth it) by a repairman.
Testimonial: "Thanks so much :)"
SOURCE: Replacing LDC screen on Fuji Z10FD camera
Probably, yes.
Remove the 2 screws on the side,
Remove the 3 screws in the buttom. (2 of which are tri-wing)
Remove the 2 screws in the battery compartment.
Flip out the chrome side (from the front backwards)
Remove the 2 screws underneath the chrome side.
Turn the camera upside down. You can now flip the backcover down (gently lift the cover, both on the mid by the tripd hole and on the side, where the crome plate was) Watch out for the USB connector.
Gently lift the broken LCD out. You need to release (flip up) the tiny white lock on the connector to release the ribbon.
Assembly same procedure, but backwards.
Beware of the flash components. The can give a nasty electrical chock.
99 views
Usually answered in minutes!
×