Help my hunter thermostat wont cool off my house til 900 pm every nite...any ideas?

MICROWAVE PROGRAMMABLE AUTO NITE LIGHT Some over-the-range microwaves had a programmable Auto Nite Light feature, which will turn the surface lights on low on at a specific time. The Auto Nite Light feature can be set to turn on and off at any time desired.
Follow the directions below for set-up:

1. Press the AUTO NITE LIGHT pad.
2. Enter the time the light is to turn on. Select A.M. or P.M.
3. Press the AUTO NITE LIGHT pad again and enter the time the light is to turn off. Select A.M. or P.M.
4. Press the AUTO NITE LIGHT pad once again.
5. The word NITE will show in the control window as a reminder that the feature is set. The settings can be reviewed by pressing AUTO NITE LIGHT.

To erase the settings and turn off the automatic feature:

• Press the AUTO NITE LIGHT pad, then press the ZERO pad.
• The NITE indicator will no longer be lit.

..

What about one for cool only, and one for heat/cool ?

change your a/c its dangerous to use it still

To change the time, press Hour once. Then press and hold Hour to until it reaches the correct one (pay attention to the AM/PM notation). Do the same with the Min and Day buttons. Press Return when done. (The thermostat will leave return to the normal mode after 10 seconds without a button press.)

Now to set the program, set the switch to heat or cool depending on which you want to program first. Press Prog (this will program M-F settings) then press and hold Hour until the time you want Prog 1 to start. Press the Up or Down arrows to get to the temperature you want to reach and stay for this period. Press Prog again and use the Hour/Min/Up/Down keys to set the time and temperature for next period. Repeat for program 3 and 4 for weekdays. Press Prog again to do the same thing for the 4 possible weekend program segments. Any time left at 0:00 results in a program being skipped.

Press Prog to set the Program. These settings will not take effect until the next time change in the program. You can review the settings by pressing Prog and scrolling through the settings.

Change the switch to the other setting and repeat the programming if your system has both AC and heat.

If you want to press the AutoProg button the thermostat will use preset times and temperatures. For Heating that is 5 am 68, 7 am 60, 3 pm 68, 10 pm 62. For cooling it is 5 am 78, 7 am 85, 3 pm 78, 10 pm 82.

For more information, you can get the manual from Hunter: http://www.hunterfan.com/Support/Manuals-and-Parts-Guides/ , just enter the model number in the Search line.

I hope this helps.

Cindy Wells

Having a problem with my fan staying on continuously even after my furnace has finished heating. Cool air blows throughout the house all day and night.

Teresa
have a cental air guy in for a check up on your units. they may need servicing

Do you have a programable thermostat? It probably is not the capacitor, maybe the compressor overload
which cuts the unit off if it gets to hot.

Have you cleaned the condensor?

http://www.hunterfan.com/uploadedFiles/Support/Owner_Manuals/44002.pdf

I would like some help programing the thermostat in my house. Hunter, Model 44300A

Thanks,

Here is a link that will have wiring diagram it is for a similar model hunter. Also check your dip switch on the back of the stat to ensure it is set for gas (HG) or electric heat (HE) depending on your type of unit. Good Luck. Rule of thumb for most four wire systems is RED (power to stat) Yellow (Cooling) Green (Fan) White (heat)