That should be answerable but first read the instructions they contain some amazing information. I can not help you because I have no idea of what you want to know.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The speaker may have a current sensing device to avoid damage under high volume conditions. Also check the setting of your bass control. Every 3 db increase in setting doubles the power going to the driver and it is easy to over drive the unit at high volumes if your bass control is not on flat.
Please follow these instructions to create a new partition on your current hard drive Go to: control panel
administrative tools
computer management
storage
disk management
right click on your hard drive
select shrink volume
enter the amount of space you want for your new partition
select shrink
you will then see a section saying unallocated space
right click unallocated space
select new simple volume
then next
select the amount of space you want for your new volume and select next
select a letter to assign to the new partition then select next
in the volume label box type the name you want for your new partition
select next and then finish and wait for the format to finish
You have just successfully created a new partition
Is everything cleaned, and the needle seems clean , but then it aint and clean the record real good, not with a simple brush.
But the questions gives me questions , is it cutting with scratching?
then i'd like to know your scratch unit, since some tt are too slow to scratch with. And you'll be surprised which they are..... 500dollar plus
check your speaker impedance by multimeter normally speaker ohms range from 8,6 or 4 ohms see your speaker spec. possibility speaker short, so impedance become too low when driving with strong bass become over current and cut out. if this is the problem the only solution is change the speaker only.
This is cause by many things one of which is a faulty speaker that is going short when operated at high volume. Another is the wiring supply the power to the radio is not "thick" enough hence not able to supply the demand for extra current. Had this same problem with Golf II which I replaced the main supply wire and after that it went to full volume with no cutting off.
you may be using an equalizer? try to pop-up the volume with all tone controls in flat mode. see if it still cuts off. if this is the first time youencounter this then something must be wroing with either your speakers or your amp. unless your ventilation is not good enoughg, you can also try placing a blower on top of your unit to cool it down
The over-current LED tells you that you're driving a lod lower than the amp is rated to drive. You either have the wrong speaker ohm load, a shorted wire or a defective speaker.
Check the power /voltage printed at back side of speaker ,test w/ volt meter /if supply not enough current to drive the amplifier.The sound are very low and humming.
You may have speakers of an incorrect impedance attached to the unit since the problem occurs when audio signal level is increased and the current goes up.The unit is shutting down to prevent damage. I would check the speaker connections and make sure that the speakers impedance are matched for the unit you are using.
×