How to fix a epson stylus pro 4800 with 00010034 Eject Roller lifted (Customer Safety Sensor on the eject roller)?

Need to check roller this is roller problem.

The camera's firmware has sensed a jam or too slow rotation in the cassette's take-up roller. Really difficult to overcome. The tape may already be snarled round a roller, but is certainly in the "loaded" tape path. I've had this and had to disassemble the whole tape transport mechanism - which is really difficult - after trying unsuccessfully to drive the unload motor from an external 6v power supply. Sometimes a really hard sideways bang on the camera can free up the roller enough to let it rotate a bit, satisfy the motion sensor and allow an eject.

Alex_Garton:

I'm not familiar with the Epson Stylus printers, but I'm going to hazard a guess. If the paper does not move at all, the paper pickup feed mechanism is at fault. One of two methods is used to pick up the sheet. Either the front lower portion of the tray is lifted up to force the top sheet into the feed roller, or the feed roller is connected to a drop-swivel to drop the feed roller onto the top sheet of paper. You'll need to look carefully at the feed mechanism to determine if a gear or clutch is failing. If the paper moves into the machine about 1/2 inch and then stops, either the first paper feed roller past the pickup roller may be at fault. Also check to see if the paper sensor between the paper pickup roller and the first feed roller is working properly.

How to fix my Epson stylus TX110 paper stack down in the roller?

. First thing to do find, if there's a foreign object that stack into the roller. If there's remove it so that it will continue feed paper.
. Secondly clean the sensor gear of the printer. If the sensor gear will have dust stick on it it will cause unnecessary moving of gear.

That's what can i help...
Try it..

yes it sounds like the eject rollers are not kicking out your doc properly. You do do not say what make or model you have so its impossible to help you further. However, if you have an eject roller which contacts another roller either above or below the eject roller then I susect they have unequal pressure. Bend the roller holder so it bears down on the eject roller with more pressure.
Good luck

ithink problem come from paper roller, maybe the paper roller is broken, or gear box of the roller is nor connect properly, contact srvice center to fix it

There is only one feed roller on the cx4800. You can take a terri cloth or other soft cloth and put a little simple green on the cloth. If you look down inside the area where you put the paper you will see the tire. You can hold the wet part of the cloth on the tire (not to hard the tire has to be able to move) and hit the load eject button. Be careful you don't let the printer pull the cloth into the feed unit. Do the load eject a few times with the cloth and you will see the dirt and ink come off. Then run at least one cycle with the dry part of the cloth. That should do the trick.

Turn off printer
Hold PAPER SOURCE+PAPER FEED+CUT/EJECT buttons at the same time and keep them pressed
Turn on printer
Release buttons
Hidden new menu appears
press DOWN, “CLEAR COUNTERS” option should appear
press RIGHT
press UP, “MAINT TANK” should appear
press RIGHT
press ENTER (CUT/EJECT button)
Turn off printer.

try pressing the load/eject button and switch off the printer then switch on again

turn off the unit wait 30 seconds and turn back on it happens to me once in a wile.