My emachine wont turn on - E-Machines Computers & Internet

When you turn it on, what happens, give as much detail as you can.

Power supply is most likely your problem--many desktops with this issue have before it happens an issue where it has to be turned on several times and will finally come on and stay on.

The power supply in most cases is a unit that can be removed and tested (most shops charge little or nothing for this.)

If you are able to get it out look for bad filter caps on that board--some examples:



If puffy caps are found you have two choices---replace them all or if possible buy a generic power supply replacement............

check plug for monitor power and also cable from pc back end to ensure they are fully inserted

let me know

TRY CHANGING THE BATRY

Your battery is not being charge you will need a new adapter it is not supplying a charge for the battery or the battery is not holding a charge. There may be a compatible charger for small fee located on Ebay for your model . 2. Contact the manufacturer for a replacement. There will be a charge.
Here is their support site address:
http://support.emachines.com/em/driver/nb/e625.html
3. they will require to know what you unit has that is ram, hard drive, video card, model no.

it looks like your hard drive may have gone bad.

its the motherboard its fried. time to rebuild and upgraded

flip the little red switch on the back of the power supply and try it again

well this would be more simple for me since i have more than one pc so first thing i would do is try another power supply if that wont turn it on then i would say mobo, the PSU's of the emachines are **** and dont last too long...
well i would try the PSU first since its cheaper.
good luck

There may be many causes.

First, if you get any Beeps, recommend you to remove and reinsert the Memory(RAM) sticks.

Do try booting after removing the CMOS Battery(The one like a coin on the motherboard). Check the manual for instructions to remove the CMOS Battery.