Amigo problem what is wrong if when i press to go forward and i go but it like stutters like its grabbing somewhere like a fast stopping while it is going..

It sounds as though power is only struggling through to the motor intermittently.

Ignoring the possibilities of loose or bad connections or expensive circuit boards the motor could need new brushes.
I have had my machine nearly ten years and it is on its fourth set even though it doesn't get used very often.

I suggest you stop persisting with attempting to make it go. If brushes are the problem you could be making things worse so that it could need a new motor rather than some routine periodical maintenance.

I could be completely wrong - sorry if I am.

Press the vcr button then press menu,press the play or stop button to select vcr set up,then press the fast forward button.Press play or stop button to select language,then press the fast forward button.Press the play or stop button to select English or Spanish.Then press the status exit button.Hope this helps.

That is typically a motor issue. It could be a few more specific things such as; transaxle, parking brake or motor brush. All of which can be quite expensive to replace.

If the featured is enabled at the phone company, grab the main line, enter call forward code (maybe *72), get stutter tone, dial your cell number, hang up. In the morning cancel forwarding, access main line, dial cancel code ( maybe *73), hang up.

Anything with a cassette in it has belts and capstans, play heads and runner rollers. The belt is likely stretched and sticky, replace it with a new belt. I use a product called rubber renue on the roller to stop it from sticking to the tape.

You'll need to have someone scan the computer for the codes.
Most auto parts stores will scan for free in hopes of selling you some parts. Once you get the codes you can research them online or in this question.

I tried the above steps, but each time when restarting the DVD player, it said 'reset' and asked for the language to be selected again. Pressing the "Fast Forward Fast Rewind Fast Forward Up Down" sequence caused the player to lock up and require powering off at the wall.
I found on another web site that there are different initial sequences. Once I use the one for Region 2, it worked fine.

I found the instructions below on another web site, but it worked for me...

• Make sure there is no disc in the player.
• Turn on the player (you can use remote control or front panel, it doesn't matter)
• Wait for "No Disc" message to appear on the TV screen.
• Press the Repeat button on remote (plain, not A-B).
• Press the correct sequence of buttons of remote according to the original region code of your player (it's on the sticker on the back panel of the player). FF = fast forward, FR = fast rewind.
• Region 2 players: FF, FR, FF, UP, DOWN
• Region 3 players: FF, PLAY, FR, UP, LEFT
• Region 4 players: FR, PLAY, DOWN, DOWN, RIGHT
• Region 5 players: FF, UP, DOWN, STOP, RIGHT
• Region 6 players: LEFT, RIGHT, RIGHT, PLAY, LEFT
• If you pressed the correct sequence, a small white number 0 will appear somewhere on the top right of the screen. The white number 0 of the same font and size as the "No Disc" message, so don't confuse with the red "not allowed" sign that would appear when you press a function that's not available.
• Turn the player off and on again, then you can pop in a DVD of any region and watch immediately.

Good luck!

you may want to try fast forwarding at 2x (that is, press the FF key twice), although the speed will be faster, it may actually stop for you, when you press play, rather than going to the end.

Mabe the RPM is too fast, check your idle seting.