Wont move i unpluged a battery on a good bike and placed it on a bike that wont work the bike that doesnt work still wont work with this battery that works in another bike.I checked the fuse its good

did you leave lights or key turned to on position or the battery didn't have a good charge when you parked it. Did you kick start the engine? Bike may need a tune-up.

I have the same issues,only the rev counter works but the di gi speed is all over the place,then had "no cdi" indicator on display,,bike wont start now just coughs n splutters,ten cuts out,i think the is a cdi issue,dealer collecting bike tomorrow i will update after diagnosis.

Battery needs to be over 12v for the bike to start, with the bike running it will be about 14v
if you charge the battery and it wont hold 12v----new battery
If the bike starts and doesnt show 14v aprox---- new regulator

If the battery is up, and the key is the right one, nobody messed with the disabler system, kick stand up? Bike in gear? Check the ignition relay, make sure bolts are tight, not corroded, check battery terminals, check water in battery, if it has water, check the wire to the starter, not corroded, broken, and the last place to look, if it hasn't started yet, is behind the headlight , there is a plastic case full of wires, it gets wet and corrodes, check it out, it would be the last place to look.

Try unpluging the cutouts.they are usally on 2-3 places on these bikes ,brakes,also check the fuse that is on the red wire comming off the battery it will be blown or end of fuse holder will be pushed in and not touching the fuse.

First thing is to make sure you don't have motor oil in the engine. Wet clutches and motor oil are not compatible. Use only the oil sold at motor cycle shops. Do that before tearing into the engine or making any radical adjustments. Good Luck -Ned-

make sure the clutch cable is properly adjusted, next thing would be to check if your clutch itself is in good condition and adjusted. to test, pull clutch lever in (with bike off) place it in gear, bike should move freely when pushed forward.. if that is all well and doesnt work good, you need transmision repairs,shifting forks probably bent.

try charging the battery

On the bottom of the mouse is a little tiny button that say: connect or reconnect. Place the mouse close to the transmitter dongle (the do hicky comes out of a USB) and look for that button on the transmitter and the mouse to reconnect the signal.
(batteries are good ?)