What does start fault 1sl means - Ingersoll Rand SS5 Electric Air Compressor Start Up Kit 20100251

From info supplied you have a y-delta start unit. when starting unit should pull in 1m(left )large contactor and 1s(right) small contactor. After approx. 10 seconds 1s starter will drop out and 2m (middle) Large contactor will pull in. Ther is and aux contact between the 2m and 1s contactor which keeps both contactors from pulling in at same time. This is the aux contact that needs replacing.

I am not sure I understand what you have going on here, do you mean the security light is on but the car starts? If so then there is a fault in the security system sensors or wiring and when that happens the light doesn't mean the system is armed it means it is sensing a fault..

if you have to use easy start then you have a problem where are you spraying the easy start for the engine to start ? P1145 has no meaning with out and engine or model there are lots of engine codes and engines with this code and they mean different things. i'm thinking if it runs with easy start. then it could be a air problem, blocked vent but then it would shut down again, same with fuel fault. you may not be getting any and its just burning the easy start. that could be the fuel pump or relays for the fuel or the injectors. but as not knowing the engine model etc could not say.

anti pollution fault with fault codes poo87 poo93 i changed fuel filter, so far all ok.

Hi Rich Stuck,P0700 means Transmission Control System (MIL Request),P1684 means Battery Disconnected within last 50 starts.More read Diagnostic Trouble Code Table ,hope it can help you.

when does it shut down and what is the temp and pressure when it goes down.

count the number of flashes- this indicates fault ie will flash 4 times stop, flash 4 times stop. To clear fault, hold start button for 3 secs. Try running another fast cycle- if fault reoccurs count flashes: Number of flashes:1=NTC fault, 2=Flood switch activated, 3=Heating fault, 4=drain fault, 6=water inlet fault, 7=flow meter fault, 8=water level fault

Didn't actually find any fault, I just held the three buttons in together on the front for a short period of time and it reset itself. Technogolgy??

code e30 means motor fault. this can be just motor brushes, tacho fault or module fault. can't narrow it down more than this - you will have to dive in and check

f is fill fault to much or not enough water or water in the sump white plastic base the f code will not go away until you solve the problem when the f code shows up the drain motor will run all of the time