KV-29LS30E OPC REPAIR - Sony FD Trinitron WEGA KV-32HS510 32" TV

we are not SHARP tech support .try a local repair service

Service manual may have information:

https://www.manualslib.com/manual/1054779/Sharp-Lc-46sb57u.html?page=64

Unfortunately, another possibility of a part failure:

https://www.justanswer.com/tv-repair/5yahn-sharp-lc-46sb57u-tv-blinking-error-code.html

OPC = OLE for Process Control. OPC is a software interface standard that allows Windows programs to communicate with industrial hardware devices. OPC is implemented in server/client pairs. The OPC server is a software program that converts the hardware communication protocol used by a PLC into the OPC protocol.

This tv still under warrenty?Yes take ur warrenty repair.This problems very common on Sharp LCD tvs.I have one too.This tv have a Tuner signal board problems.But this tv still use able.Just push power button again after the POWER and OPC flashes.POWER and OPC some will flashes again and wait just push the power button again and wait.Sometimes have to push power buttons and wait power button push out of three or four times power button push POWER and OPC flashes.Than tv will work again.

Set Belt CG The OPC belt cartridge needs replacement.

Replacing the Optical Photoconductor (OPC)
Belt Cartridge
Replace the OPC belt cartridge at least once every 12 months, or when
the control panel display indicates that replacement is necessary. The life
of the OPC belt cartridge for the T8106 is about 60,000 images (15,000
color pages), at a 5% toner coverage rate on letter-size paper.
1. Turn the power switch off.
2. Unlock the lever to open the front
cover. This releases the pressure on the
toner cartridges.
3. Unlock the lever to open the top cover
fully.
4. Pull the green OPC belt cartridge lock
levers up until they unlock.

5. Pull the used OPC belt cartridge
upward and out of the printer carefully
to avoid spilling toner.
6. Discard the used OPC belt cartridge
Caution! Do not touch or wipe off any powder that is on the OPC belt, nor expose
the OPC belt to light.
7. Remove the two shipping pins from the
new OPC belt cartridge.
8. Remove the protective sheet that covers
the photosensitive belt.
9. Slide the new OPC belt cartridge downward
into both green lock-lever guides
and into the printer carefully.
10. Push the green OPC belt cartridge lock
levers down until they lock.
11. Close the top and front covers carefully
until they both lock.

The opc sensor is not sensing the belt. Open the front cover and remove all the toner trays. You will see the green OPC and the sensor is located in the left upper corner. Also open the top cover and remove the OPC. Clean the sensor with a soft bristle brush. Also make sure the OPC left side is free of toner deposits. This may incorrectly trigger the OPC position sensor. Hope this helps.

try again

Dear tporteous,

Your unit requires replacement of the OPC belt. this is a consumable available from most suppliers of laser products. It is easily installed and the reset is in the menus on the printer.

Now the bad news, the opc belt will retail at something over the $600 mark and to be honest, most people who are in your situation simply go out and buy another printer. The whole unit retails at about $900 if you shop around.

Sorry dude.

Gremlin11

When i set the TV on it's not open but the red led lights on-off 11 times.In service manual said than the error is in 8v in jungle I.C .That means the jungle IC is off?
The 8v comes out from jungle I.C or the power supply?
THANKS