Replaced coil an plug no spark - Poulan P3314 14" Gas Chain Saw 2.0 Cuin 33CC 2 Cycl

The 3000 mule I have worked on has a coil, wire which screws into the coil and spark plug boot.
Do you have power and ground connection at coil.
You said you replaced coil did the wire and spark plug boot get replaced also.
If there is any question about the connection between the coil, wire and boot you might try removing the coil, wire and boot from back cylinder and placing on front. Swap them and see if you loose spark on rear plug after swapping.
Just a thought.

If the coil pack has a four wire connector, one wire is primary voltage, the other three wires are ground, one ground for each coil, one coil fires two spark plugs. If problem with coil or ground, you would lose spark for two spark plugs. Did you visually check for spark, everywhere? What about the spark plug wire or the spark plug, itself?

This unit should have a magneto not a coil so better find out what you replaced and check with a dealer or repair centre for your model

ignition will trigger if signal from crank sensor, with hei spark plug tester ,read to coil wire and spark plugs wire if spark , depends wich engine
if c3i coil and module the module could be the problems you can check it before replace
hope it helps

sounds like a bad crank sensor. it tells computer when its time to fire the spark

Steve:

Yes, the spark plug wire can be replaced, but you have to buy the ignition coil as the spark plug wire is hard wired into the ignition coil.

If the metal spark plug connector has disconnected from the spark plug wire, the connector can be replaced, but if the spark plug wire has been cut you'll need to replace the ignition coil.

No spark.This is indication of faulty spark plugs.But spark plugs get power to spark from coil pack. So get the connection between coil pack to spark plugs checked.If it checked out ok then its faulty spark plugs that has to be replaced,but if coil pack has no power then its faulty coil pack that has to be replaced.But if coil pack and spark plugs both checked out ok then this problem is fuel related problem.In this case the fuel pressure needs to be checked.The fuel pressure can be easily checked at any local car garage.If its low then its faulty fuel pump as well as clogged fuel filter,which has to be replaced. The voltage for spark plugs and coil pack in voltmeter will show 12 volts.Its a 12 volt part.If there is no or low volt then there is problem with the part. ------------------ Keep updated with any more queries.Thanks.

did you replace the coil wire?
and distrubtorcap and rotor?

If it's the four cyl., the first coil pack bolts over the #2 spark plug. The #2 coil pack wire plugs into #3 spark plug. The number two coil pack bolts directly over the number four spark plug, and the #2 coil pack wire plugs into the #4 plug. The firing order is 1-4-2-3.