Sanyo washing machine

What is a problems with my washing Machines? Suddenly on the screen board the word E2 appear and Washing Machines is stuck and can not be used

http://electrotechnician.blogspot.com/
https://electronicshelponline.blogspot.com/
http://homenol.blogspot.com/
Please visit these sites to get some details.

Old code E2 New code 5E.

FAQs My washing machine is displaying an error code What does it mean...

What is the make and model number of your unit?

mungkin

barangkali

agaknya

')" onmouseout="ht(this)">perhaps pintu

daun pintu

laluan

')" onmouseout="ht(this)">door tidak ditutup

tak bersalut

')" onmouseout="ht(this)">uncoated dengan betul')" onmouseout="ht(this)">properly or penapis

tapis

menapis

')" onmouseout="ht(this)">censor in pintu

daun pintu

laluan

')" onmouseout="ht(this)">door gagal

kecewa

terkandas

')" onmouseout="ht(this)">failed. menghubungkan

sambungkan

menyambung

')" onmouseout="ht(this)">connect pendawaian')" onmouseout="ht(this)">wiring penapis

tapis

menapis

')" onmouseout="ht(this)">censor with ( 2 dawai

wayar

kawat

')" onmouseout="ht(this)">wire ) jika tiada

sekiranya tiada

sekiranya tidak

')" onmouseout="ht(this)">if no dawai

wayar

kawat

')" onmouseout="ht(this)">wire penapis

tapis

menapis

')" onmouseout="ht(this)">censor menggunakan

penggunaan

gunakan

')" onmouseout="ht(this)">use magnet

besi berani

batu berani

')" onmouseout="ht(this)">magnet diletakkan pada')" onmouseout="ht(this)">placing at mengenai kawalan')" onmouseout="ht(this)">on control litar

lingkungan

peredaran

')" onmouseout="ht(this)">circuit

get the manual at manualfox.com

I have an E2 error on the display of a homemaker washing machine model no HMWM8000. It will not pump out. The PCB does not have any visibly damaged components, which part is faulty, and how do i test a water level sensor.

Telemann TEL6tl E2 Problem

E2 on screen means the lid is not closing properly and thus not activating the (hidden) switch that prevents the machine from spinning while the lid is up.

The lid switch in this model is not a direct contact switch between lid and switch , but it switches on and off due to a MAGNET embedded in the lid on the left hand side near the front. You will see a small indentation where the magnet SHOULD BE. My magnet had fallen off, so the lid could not activate the operation switch. I had lost the original magnet( about 1cm X 2cm) so glued another into place.

Machine is now fully operational again, and the job cost .78c.

If your magnet is still in place, the E2 fault could lay with the switch itself , which is fixed to the underside of the top casing of the machine near the front right hand side of the lid cavity. The switch measures 1cm X 3cm heavily black tape insulated. Access is gained by popping the 2 X2cm discs at front top of machine and releasing the 2 small philips screws here and a further 2 at the back top of machine. This operation of replacing the switch is best left to an electrician or washing machine specialist.

Hope that helps

Apostle95