Nortle bap 120 firmware - Nortel Computers & Internet

Do you have your user guide or owner's manual? Read that thoroughly and you will have no problems. If you don't, get one from the manufacturer - search their website and download.

You are never allowed to disconnect power during firmware upgrade. If you do, there is no way to recover from it, except to unsolder the firmware chip and install a new properly-programmed chip.

OK here it is.

Dada is 84 years old (grandfather)

Baap is 49 years old (father)

Pota is 7 years old (grandson)

Check: 84 + 49 + 7 = 140 years

Read below if you want to know how to solve (Its a simultaneous eq. of 3 variables bdw :)):

Let Dada be D years, Baap be B years and Pota be P years

D + B + P = 140 (given)----------------------------- (1)

Constraints:

D = 12P; --------------------------------------------------- (2) 1 year is 12 months; 52 weeks; and 365 days

52B = 365P; --------------------------------------------- (3)

Substitute value of P from (3) into (2) therefore D = (12 * 52/365)B ------------------- (4)

Put (4) in 1 to get

(12*52/365)B + B + (52/365)B = 140

This gives B = 49 years. Put in above eqs to get other values.

Hi there,

Please send message in english.

Thank you

there might be a reset button in the back of the router or you can try your routers ip address or give them or your ISP a call and tell them to reset it.

Try visiting http://www.s1mp3.com and http://drivers.softpedia.com/get/firmware . There is a large collection of firmware database.

Can your laptor detect any other networks? If not make sure that your wireless switch is turned on.
If wireless switch is turned on and laptop detects other networks then your router is set not to transmit ssid (check router manual on how to configure SSID transmission mode).

I might advise you to reconfigure the access point, maybe it lose the connection from before, reconfiguring the access point will going to have the previous performance.

there should be a small pin hole somewhere on the top of the unit. Stick a pin in there hold for about 3 seconds and it should reset.

I just found 1 of my power steering leaks in my 1990 toy pickup. My high pressure line has a hole in it. I used a florecent die kit to locate the leak. You can get it at Autozone.