Power cord I have to replace power cord but I have no idea where it plugs into on the tv

If you've already tried resetting the TV to factory settings and replacing the Power Supply/LED Driver board, the next step would be to check the power cord itself. Here are a few steps you can take to troubleshoot the power cord:

1. Make sure the power cord is securely plugged in: Check that the power cord is plugged in firmly to both the TV and the wall outlet.
2. Check the power outlet: Plug another device into the same outlet to make sure it's not a problem with the outlet itself.
3. Check the power cord for damage: Inspect the power cord for any visible damage, such as frayed or broken wires. If you see any damage, replace the power cord.
4. Check the voltage output: Use a multimeter to check the voltage output of the power cord. The voltage output should match the voltage listed on the TV's specifications.

If the power cord appears to be damaged or not functioning properly, you can try replacing it with a new one. If none of these steps resolve the issue, it may be a problem with the TV's internal components and you should consider contacting Samsung support or a qualified technician for further assistance.

Perhaps replace your power cord. Borrow power cord from repair shop. If it works it's the cord. Also if the TV is plugged into power bar make sure the power bar hasn't been inadvertently turned off.

The tv power supply board it is shorted and dead.That the board where the tv power a/c cord plug into it.Tries websites like Shojimmy.com,Ebay.com to buy a whole new refurbish tv power supply board for the replacement.

Tries unplug,replug the tv back like an hour later.The tv now,is resetting back to factory setting.The tv should work now.Not,than the power supply board have problems.That the board,where the power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.

Yes,the power supply board it dead.That the board,where the power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.

The power supply board is defective.That the board where the a/c power cord plug into it.Take ur tv aparts,replaced the power supply board should solved this problems.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.

The power supply board is dead,that the board where the power cord plug into it.Take ur tv aparts,replaced the power supply board,ur tv should work again.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.

I have a Westinghouse Mod. SK-19H210s that is 16 months old. It would not turn on. Upon investigationg the problem I discovered bad capacitors on the power board. (2200uf and 1000uf). I replaced the components and the TV works great, you can purchase a new power board.

Unless this set is really oddball, it probably has the same type power cord connector used on computers and so many other electronic appliances. If this is the case, you can use a standard computer power cord as a replacement. The computer cord is a three-wire plug with a ground pin and the TV probably only had a two-prong plug, but the cord will still fit. Your electric outlet should be the three-prong type (if it's not, get it replaced!) so the plug will fit.

If the connector in the set is really different, you can check online by doing a Google search for replacement parts for you TV.

Hi,

Have you tried Toshiba Phils? Perhaps tehy can help, here are their contact details should you need it.

Alternately, if you are anywhere near Gonzalo Puyat (formerly Raon) you can try bringing the AC adapter and try fitting replacement power cord readily available on most stores. Additionally, most electronics part stores carry generic/replacement power cords and one should fit.

There are some versions that uses the same power cord as that of a desktop PC.

If you need the entire power adapter with cord, pls try here or here. Incidentally, any power adapter rated at 12VDC output @ 4amps should also work, you just have to make sure the polarity of the crown plug matches the Toshiba.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.