- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
A steady blue light on your NEC-SL1000 system usually indicates that the system is in standby mode. However, the lack of a dial tone on all local lines indicates a problem with the system or phone lines. Here are a few steps you can try to troubleshoot the issue:
Check the phone lines: Make sure that all phone lines connected to the system are properly connected and not damaged. If you have multiple lines, test each one individually to determine which line is causing the issue.
Restart the system: Turn off the system and unplug it from the power source. Wait for at least 10 seconds before plugging it back in and turning it on again.
Reset the system: If restarting the system doesn't work, you may need to perform a system reset. Refer to your user manual for specific instructions on how to reset your NEC-SL1000.
Contact a professional: If none of the above steps work, you may need to contact a professional NEC-SL1000 technician to diagnose and fix the issue.
It's also possible that the steady blue light is indicating a different issue altogether. Again, refer to your user manual or contact a professional for further assistance.
How to Reset a NEC Projector Lamp Timer. Make sure the projector is in standby mode; Press the Off or Help button on the remote control for a minimum of 10 ...
NEC reset lamp without remote Questions & Answers - Fixya
My bulb warning had just recently appeared a few weeks prior, so I thought the bulbmust ... ...reset the Lamp timer o an NEC MT1050 projector. ... ...reset lamp usagetime without the remote on NEC VT490 HelloPress the MENU button on the ...
reset lamp hours nec projector without remote Questions ...
www.fixya.com > Forum > Tags
Find solutions to your reset lamp hours nec projector without remote question. ... My nec vt48 projector gets hot and turns off. It ... Question about VT700 Projector.
Power supply board have problems.Tries unplug,replug the tv an hour later,the tv now,will reset itself back to factory setting.The tv should work now,not than the power supply board is dead.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.
you can go on ebay and get a battery for an nec m5410, they are the same
Does the battery in an nec m5410 work in a nec 5210? I have an nec m5210 computer and need a battery, it looks like BATTERY FOR THE M5410 may work but i want to certain before i order from ebay HELP!!!!!!!!!!
1 month ago
Report Abuse by DavidG Member since:07 June 2008Total points:15365 (Level 6)
When the lamp exceeds 2100hoursof service, the projector cannot turn on and the manu is not displayed. Do the following: For VT670/VT470 Press the help button on the remote control for a minimum of ten seconds. For VT570/VT47 Press and hold the power and the exit buttons on the remote control simultaneously for a minimum of ten seconds. When the lamp time clock is reset to zero, the lamp indicator goes out. Hope this helps! :]
you have to reset the filter in the controls or it will continue. i cleaned it everyday for a week until i got fed up and went into the last setting (by the lamp hour reset) and reset it. good luck
×