Access the manufacturer's web-site:
ftp://ftp2.dlink.com/PRODUCTS/DCS-950G/REVA/
and pick the device-driver.
SOURCE: D-Link DCS-G900 Network Camera setup
http://www.dlink.com/products/?pid=270
go here and on the right under support resources select application.
SOURCE: download software
You can download the driver from the following link :
http://driverscollection.com/?file_cid=390169192057c4f19a60c24a889
I hope this will solve your issue.
Good Luck.
If my solution proves useful please accept it.
Regards
Arjun
SOURCE: My DLink 5300 G internet camera suddenly says "No Signal."
SOURCE: DLINK - DCS-900w Firmware Update needs install software?
Go to dlink.com. Select IP cameras. At the top is a search using Product Quick Find. Find the 900w and click on it.Select Support Resources. All the firmware and software is there.
SOURCE: how to setup aztech router
Install the installation disk of the ipcamera. Configure the ipcamera base on your requirements. Then install the ipcamera on the position you require.
226 views
Usually answered in minutes!
×