Hitachi tv 60fx32b comes on then turn red - Sony KP-51WS500 51" Rear Projection Television

Try to plug it into a different electrical socket and try it without any extension cords or power strips (sometimes the socket or extension cord is to blame)

Convergence is adjusted with Hitachi remote and to get into mode you remove speaker grill (on model indicated) and locate small blue button on front of chassis--with set on press button and grid of lines comes on.

If red is really bowed and will not adjust----the convergence chips need to be replaced.

If not a convergence issue: each tube (back of set) has a large black lens with a wing nut on side----loosen nut and rotate lens slowly until red is in focus.

We had it fixed by an expert, replaced two STK 4274 Resistors, only cost $300.00, works great now.

need a manual for a HITACHI DZMV550A camcorder

The two other fuses look like resisters. My suggestion would be to check them first and if bad use a temp of the same rating to see if it was just a power surge.

Remove rear cardboard cover....can you see tops of red / green /
blue tubes ? Clean lens' with soft , dry cloth......Do you smoke ?
If not , replace back. Picture should now be clearer but not
necessarily brighter.......Next, remove front speaker grill and find
the RGB focus / screen adjust block....turn RGB screen controls
SLIGHTLY clockwise to achieve more brightness....not too much
or you will have retrace lines in background of picture.......Let me know after these steps are done........T.

When you turn on the TV do you hear 3 clicking noises then the TV turns off?

Replace vertical output IC with first quality part,check caps
in vertical power supply......If you don't have access to parts,
then solder pins of IC,should hold for awhile.
If you need further assistance, let me know.....T.