Lid switch is not good

Is the plunger attached to the lid? It is the little prong that goes into the lid switch.

You have a bad lid switch. If the lid switch or lid switch circuit is open the motor is not going to run. Trace the lid switch wires and look for any breaks or loose connections. If that circuit is good, then you have a bad capacitor on the motor circuit or the motor is bad. Here is a link to the motor kit should you need it.

Its either in the lid switch or timer. Examine the lid switch. Try starting the wash cycle and press in on lid switch to make sure it activates. If the lid switch is good and you dont hear the motor trying to activate during wash than its in the timer. Does the timer advance? Please comment me back If you need further assistance.

set the timer on spin,open the lid and with a screw driver stick it into the hole that the strike on the lid closes down into,see if it spins and drains,if it doesn't lift the screw driver up and push it down into the hole,if you don't hear any clicking at all the switch is bad or if it does start with the screw driver the lid switch also has to be changed out.check this site out,also give the parts store the model number off of your washer to get the correct lid switch or next time send the model number and i can look up the part for you.good luck and let me know how you make out.
YouTube - Washing Machine Lid Switch Replacement (part #3949247)

kds e2 means lid switch is not being engaged .remove rear top cover .2 phillips screws .3 snap clips use flat blade screw driver to pop cover .look at rear of lid (door) right side plastic arm part of lid snaped off replace lid part xqb5526f.1.3-3 check saftey switch manually over ride switch as a test .if machine spins change lid if switch broken as well change both .switch # xqb550.1.6

You need to chang the lid switch if there is a clicking sound then the switch is good, you will have to readjust the lid

Good day,
Common problem, Change the switch, and make sure if it is the model with a plunger for the switch mounted on the lid, that that be replaced as well.

Thank you for using FixYa

Make sure your lid switch is good. Make sure the peg is still on the lid that pushes down on the lid switch. If so you have a bad timer. Sorry, it seems I'm always the bearer of bad news.
Please rate solution.

If the lid switch is defective, your washer can't spin and may not function at all. The switch is inside the washing machine main housing near the door frame. Often you have to raise or open the top or front of the washer to get to the switch. If it's defective, you need to replace it.

Some machines have a special lid-switch fuse near the lid switch, inside the control panel. If this fuse blows, the unit won't fill with water until you replace the fuse.